JVC CA-MXJ100 Troubleshooting, Specifications, English, Amplifier, Tuner, General, CD player

Models: CA-MXJ100

1 34
Download 34 pages 1.47 Kb
Page 25
Image 25
Troubleshooting

Troubleshooting

If you are having a problem with your unit, check this list for a possible solution before calling for service.

If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.

English

Symptom

No sound is heard.

Hard to listen to broadcasts because of noise.

The disc sound is discontinuous.

The disc tray does not open or close.

The disc does not play.

The cassette holders cannot be opened.

Impossible to record.

Operations are disabled.

Cause

Connections are incorrect or loose.

Antennas are disconnected.

The AM (MW/LW) loop antenna is too close to the unit.

The FM antenna is not properly extended and positioned.

The disc is scratched or dirty.

The AC power cord is not plugged in.

The disc is placed upside down.

Power supply from the AC power cord has been cut off while the tape was running.

Small tabs on the back of the cassette are removed.

The built-in microprocessor may malfunction due to external electrical interference.

Action

Check all connections and make corrections. (See pages 6 to 8.)

Reconnect the antennas correctly and securely.

Change the position and direction of the AM (MW/LW) loop antenna.

Extend the FM antenna at the best position.

Clean or replace the disc. (See page 19.)

Plug the AC power cord.

Place the disc with the label side up.

Turn on the unit.

Cover the holes with adhesive tape.

Unplug the AC power cord and then plug it back in.

Unable to operate the unit from the remote

The path between the remote control unit

Remove the obstruction.

control unit.

 

 

and the remote sensor on the unit is

 

 

 

 

 

 

 

blocked.

 

 

 

 

 

The batteries are exhausted.

Replace the batteries.

 

 

 

 

 

 

 

Specifications

 

 

subject to change without notice.

 

 

 

Design and specifications are

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Amplifier

 

 

Cassette deck

 

 

 

 

 

 

 

 

 

 

Output Power:

30 W per channel, min. RMS, both channels driven into 6 Ω at 1 kHz with no more than 10% total harmonic distortion

Audio input sensitivity/Impedance (at 1 kHz)

AUX: 400 mV/50 kΩ

Speakers/Impedance: 6 Ω – 16Ω

Tuner

FM tuning range:

87.50 MHz – 108.00 MHz

AM tuning range: MW:

522 kHz – 1,629 kHz

LW:

144 kHz – 288 kHz

Frequency response

Normal (type I): 50 Hz — 14,000 Hz Wow and flutter

0.15% (WRMS)

General

Power requirement:

AC 230 V , 50 Hz

Power consumption:

68 W (at operation)

 

13 W (on standby)

Dimensions (approx.):

270 mm x 317 mm x 380 mm (W/H/D)

 

(10 11/16 in. x 12 1/2 in. x 15 in.)

Mass (approx.):

6.9 kg (15.3 lbs)

CD player

CD Capacity:

3 CDs

Supplied accessories

Dynamic range:

85 dB

See page 6.

Signal-to-noise ratio:

90 dB

 

Wow and flutter:

Immeasurable

 

– 20 –

Page 25
Image 25
JVC CA-MXJ100 manual Troubleshooting, Specifications, English, Amplifier, Tuner, General, CD player