JVC CA-MXJ500 Using Recording Timer, When selecting “- CD - -”, Press CLOCK/TIMER again, English

English

6 When selecting “– CD – –”

1)Press 4or ¢ to select the disc number, then press SET.

2)Press 4or ¢ to set the track number, then press SET.

The unit enters volume setting mode.

When selecting “TUNER FM” or “TUNER AM”

Press 4 or ¢ to select the preset station number, then press SET.

The unit enters volume setting mode.

7 Press 4or ¢to set the volume level.

•You can select the volume level from among the following — “VOL – –,” “VOL 5,” “VOL 10,” and “VOL 15.”

If you select “ VOL – –,” the volume is set to the last level when the unit has been turned off.

8 Press SET to complete the Daily Timer setting.

The DAILY (Daily Timer) indicator stops flashing and remains lit. The settings you have done are shown on the display in sequence.

9 Press to turn off the unit (on standby) if you have set the Daily Timer with the unit turned on.

To turn on or off Daily Timer after its setting is done

1 Press CLOCK/TIMER repeatedly until “DAILY” appears on the display.

2 To turn off the Daily Timer, press CANCEL.

The DAILY (Daily Timer) indicator goes off from the display (“OFF” appears for a while). The Daily Timer is canceled, but the setting for the Daily Timer remains in memory.

To turn on the Daily Timer, press SET.

The DAILY (Daily Timer) indicator lights up on the display. The settings you have done are

shown on the display in sequence for your confirmation.

If the unit is turned on when the timer-on time comes

Daily Timer does not work.

Using Recording Timer

With Recording Timer, you can make a tape of a radio broadcast automatically.

How Recording Timer actually works

The unit automatically turns on, tunes into the specified station, sets the volume level to “MIN,” and starts recording

when the on-time comes (the indicator flashes just before the on-time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” appears just before the off-time), the unit automatically turns off (stands by).

The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•If you have made a mistake while setting the timer, press CANCEL. (However, this does not always work. If CANCEL does not work, press CLOCK/TIMER repeatedly and start from step 1 again.)

On the unit ONLY:

1 Put a recordable cassette into deck B.

2 Press CLOCK/TIMER until “REC” appears on the display.

The REC (Recording Timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled Clock ON TIME setting

(See page 9.)

3 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

– 23 –