JVC DLA-G150HTE

DLA-G150HTE

1-4 No.51847

Controls and Features

Front Side / Top Surface / Right Side

1Exhaust vents

Vents for cooling fans through which warm air comes out.

CAUTION

•Do not block the exhaust vents, or heat will build up inside,

possibly causing a fire. Also, do not touch the vents, or this

could give you a low-temperature burn.

2Carrying handle

Raise this handle when carrying the projector.

CAUTIONS

•When carrying the projector, do not transmit shocks to it.

Also be careful to keep it balanced.

•Do not carry it while the light-source lamp is on or the

cooling fan is operating. This could cause personal injury.

3AC IN (power input) terminal

This is the power input terminal where the supplied

power cord is connected. For details, refer to page 30.

4Fuse holder

A fuse rated T6.3A H 250 V is installed. (Power source

protection)

To replace the fuse, refer to page 56.

CAUTION

•When replacing the fuse, use the same rating and type.

Otherwise, a fire may occur and/or the projector may be

damaged.

5MAIN POWER switch

This is the main power switch. When it is turned on, the

projector goes into stand-by state, and the STAND BY

indicator on the control panel comes on. (Refer to

page 31.)

ON [ ]:The main power turns on.

OFF [ ]:The main power turns off.

6Adjustable feet (for adjusting the height and

angle)

By extending the feet, the projector angle can be

adjusted up to +7°.

For details, refer to “Adjusting the Inclination of the

Projector” on page 16.

7Lens

Projection lens, which is an electrically driven, approx.

1.5 × zoom lens. Before projection, remove the lens cap.

8Lens cap

The cap has a string attached and the string is fixed to

the projector when shipped from the factory. It is

recommended that the cap be fitted on to prevent the

lens becoming dirty when the projector is not used.

9Remote sensor

When operating with the remote control, aim it toward

this sensor. (Refer to page 20.)

LAMPTEMP

HIDE

VIDEO

KEYSTONE

PRESET

EXITENTER

OPERATE

5432