JVC DT-V17L3DY specifications Example of the wave form monitor, Wave Form SETTING*1, Sync Function

Operation guide

Shows the buttons for each operation.

NOTE

Example of the wave form monitor

Ex.: When “MARKING” is set to “ON” and “LEVEL” is set to “080”

Red White

• The wave which goes over the value set on “LEVEL” is indicated in Red.

	Video signal
Start	End

WAVE FORM SETTING*1

Settings for the wave form monitor

Item		To do	Setting value
POSITION		Select the position of the wave form monitor.	1 (lower right), 2 (lower left), 3 (upper left),
			4 (upper right)
FILTER		Activates/deactivates the low-pass filter for the	FLAT (no filter), LOWPASS
		incoming wave form data.
GAIN		Adjust the gain level for the incoming wave form	–10 – +10
		data.
OVER LEVEL		Select the over level for the incoming luminance	☞ “NOTE”
		signals.
	MARKING	Activates/deactivates the function to change the	OFF, ON
		color of a wave form when the signal exceeds the
		limit specified on “LEVEL” (☞ below).
	LEVEL	Adjust the lower limit for the luminance signal	070 –109
AUTO OFF		Activates/deactivates the function to make the	ON, OFF
		wave form monitor indication go off automatically
		15 minutes after displaying it.

*1 This function does not work for the signals as follows:

RGB input signals (digital), DVI signals (digital/inputted from personal computer), 1080/60p (analog/digital), 1080/50p (analog/digital), 640 *480/60p (analog/digital).

SYNC FUNCTION

Settings for the synchronization with signals

Item	To do	Setting value
NO SYNC ACTION	Select the screen status when no signal is	OFF,
	coming in.	P.SAVE (power save mode),
		GRAY B. (gray screen)
DELAY TIME	Select the period until the screen status	30sec., 5min., 15min.
	changes as selected in “NO SYNC ACTION”
	after signals stop coming in.
LOW LATENCY	Activates/deactivates the function to shorten	ON, OFF
	the time taken to display the picture (low latency
	function).
	• If the picture is not displayed steadily while
	“ON” is selected, select “OFF.”
	• While “ON” is selected, the displayed picture
	may become unstable when an operation
	using buttons on the front panel or the menu
	is performed, or when the signal format
	changes.

•When setting “NO SYNC ACTION” to “GRAY B.,” the screen color changes to gray and the power consumption of the back light is saved by half.

Selecting “P.SAVE” (power save mode) saves more power consumption by turning off the back light.

CLOSED CAPTION*2 Setting value: OFF, CC1, CC2

Selects the type of closed caption for analog composite signals (NTSC and B/W60 only).

• Regardless of the setting, the closed caption is not displayed when the wave form monitor is displayed.

*2 Memorized for each input (VIDEO1 and VIDEO2).

13