JVC DVL520U Guide Driver, Adjustment Driver, Slit washer Installation Jig, Jig Connector cable

2.2JIGS AND TOOLS REQUIRED FOR DISASSEMBLY, ASSEMBLY AND ADJUSTMENT

2.2.1 Tools required for adjustments

1	Torque Driver	2	Bit
	YTU94088		YTU94088-003

3	Tweezers	4	Chip IC Replacement Jig
	P-895		PTS40844-2

5	Guide Driver	6	Adjustment Driver
	YTU94148A		YTU94028

7	Slit Washer Installation Jig	8	Jig Connector cable
	YTU94121A		YTU93082C

9	Communication cable	10	PC cable
	YTU93107A		QAM0099-002

11	Service Support System	12	Alignment Tape
	YTU94057-57		MC-1

13Cleaning Cloth

KSMM-01

1.Torque Driver

Be sure to use to fastening the mechanism and exterior parts because those parts must strictly be controlled for tightening torque.

2.Bit

This bit is slightly longer than those set in conventional torque drivers.

3.Tweezers

To be used for removing and installing parts and wires.

4.Chip IC replacement Jig

To be used for adjustment of the camera system.

5.Guide Driver

To be used to turn the guide roller to adjustment of the linarity of playback envelope.

6.Adjustment Driver

To be used for adjustment.

7.Slit washer Installation Jig

To be used to install slit washers.

8.Jig Connector cable

Connected to CN105 of the main board and used for electrical adjustment, etc.

9.Communication cable

Connect the Communication cable between the PC ca- ble and Jig connector cable when performing a PC ad- justment.

10.PC cable

To be used to connect the VideoMovie and a personal computer with each other when a personal computer is used for adjustment.

11.Service Support System

To be used for adjustment with a personal computer.

12.Alignment Tape

To be used for check and adjustment of interchange- ability of the mechanism.

13.Cleaning Cloth

Recommended cleaning cloth to wipe down the video heads, mechanism (tape transport system), optical lens surface.

Table 2-2-1

2-2