![](/images/new-backgrounds/1131390/13139051x1.webp)
5. | 5a Guide roller (S) assembly/ 5b Rail assembly | ||
|
| 5a |
|
| Note 5a | (P5) | |
|
|
| |
| (W5b) | (W5a) | Note 5b |
| (W5a) | Note 5c | |
|
|
| |
| 5b |
| (W5a) |
Note 5a:
When reassembling, insert the tip of the guide roller with the coil spring put on it into the hole on the main deck. Tighten the guide roller by about 6 turns so that the height of the guide roller assem- bly is 19 mm or so as shown in the figure.
Guide roller
(s) assembly
19mm
Note 5d |
Fig. |
6. | B Slide deck assembly/ | C Main deck assembly | ||
| (L6a) | (W6) |
|
|
|
| BSlide deck assembly | ||
|
|
|
| Note 6b |
| (L6b) |
|
|
|
|
| Note 6a |
| CMain deck |
|
|
| assembly | |
|
|
| (L6c) | |
|
|
|
| |
|
| (L6d) |
| |
|
| Fig. |
|
Note 5b:
Pay careful attention to the spring not to lose it.
Note 5c:
Pay careful attention to the engagement of the rail assem- bly’s arm ends because they easily come off the engage- ment. Moreover, make sure that there is neither deforma- tion nor damage observed in them.
Note 5d:
When removing the rail assembly, check to see if the collar is securely set in the arm groove.
Note 6a:
When removing the slide deck assembly, pay heed to the three components of the following because they are apt to come off after the slide deck assembly is removed.
8a Tension lever assembly/ 8b Slide lever assembly
8c Brake control lever assembly
For reassembling those components, refer to Fig.
Note 6b:
When reassembling the slide deck assembly to the main deck assembly, combine them with each other by the side grooves and then slide the slide deck assembly by 1 mm or so.