GettingIntroductionstarted
This page is for when operating your TV using the remote control of this product.
Operating the TV using the remote control
Number buttons
Setting the manufacturer's code
1 Slide the remote control mode selector to the TV side.
2 Keep pressing down FTV.
NOTE
Keep pressing down FTV until Step 4 is complete.
3 Press ENTER and release.
4 Press number buttons (1-9, 0).
Examples:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
If there are more than one manufacturer’s codes, try them in turn and select the one that causes the product to work properly.
Manufacturer | Code | Manufacturer | Code |
|
|
|
|
JVC | 01 | Samsung | 12 |
|
|
|
|
Hitachi | 10 | Sanyo | 13 |
|
|
|
|
Magnavox | 02 | Sharp | 06 |
|
|
|
|
Mitsubishi | 03 | Sony | 07 |
|
|
|
|
Panasonic | 04, 11 | Toshiba | 08 |
|
|
|
|
RCA | 05 | Zenith | 09 |
|
|
|
|
NOTE
Manufacturer’s codes may be changed without notice. You may not be able to operate a TV produced by the manufacturer shown above.
5 Release FTV.
For TV operation
Operate the remote control by pointing it towards the TV.
Turn ON/OFF the power.
Change channels.
Adjust volume.
9 | Select channels. |
100+
*1
Alternates between the previously selected channel and the current channel.
Switch TV and video input.
*1 Make sure to slide the remote control mode selector to the TV side in advance.
NOTE
When the batteries are replaced, perform the manufacturer's code setting again.
English
8
