JVC FS-8000 manual Auto Presetting, To Change the FM Reception Mode, Press the SET button, English

■5. Press the SET button.

After 1 second, the display returns to the broadcast frequency display.

■6. Repeat above steps 1 to 5 for each station you want to store in memory with a preset number.

To cancel the presetting, press the CANCEL button in step 3 or 4.

To change the preset stations, repeat the same steps as

above.

Auto Presetting

In each band, you can automatically preset FM-30, AM-15 stations. Preset numbers will be allocated as stations are found, starting from the lowest frequency and moving up the frequency.

(for 2 seconds)

■1. Select a band by pressing the TUNER

BAND button.

■2. Press the AUTO PRESET button on the

Remote Control for more than two seconds. ■3. Repeat steps 1-2 for the other band.

■If you want to change the preset stations, carry out the Manual Presetting for the desired preset numbers.

CAUTION: If the System is unplugged or if a pow- er failure occurs, the preset stations will be erased after about 24 hours. If this happens, you will need to preset the stations again.

To Change the FM

Reception Mode

When you are tuned into an FM stereo broadcast, the “ST (Stereo)” indicator lights up and you can hear stereo effects.

If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose any stereo ef- fect.

Press the FM MODE button on the Remote Control so that the “MONO” indicator lights up on the display.

	FM MODE
ST(Stereo)	MONO

To restore the stereo effect, press the FM MODE button on the

Remote Control so that the “MONO” indicator goes off.

English

10