JVC FS-8000 Using the Powered Subwoofer, Operating the Powered Subwoofer, Presetting the Volume

■Using the Powered Subwoofer

AUTO POWER	VOLUME
ON/STANDBY
indicator	PHASE
	INPUT (LOW-LEVEL)
	INPUT (HIGH-LEVEL)
	POWER

English

Operating the Powered Subwoofer

Presetting the Volume ———————

You need to preset the volume level of this speaker to match those of the other speakers. Once you preset the volume level, it is stored as your reference level and the volume level of this speaker will be able to automatically change as the volume level of the Unit chang- es.

■1. Press the POWER button of the Subwoofer to turn on the power.

The ON/STANDBY indicator of the Subwoofer will light in green.

■2. Set the VOLUME in the “MIN” position.

■3. Adjust the volume of the Unit to your lis- tening level.

■4. Adjust the VOLUME to balance the volume with the other speakers.

To turn off the Subwoofwer, press the POWER switch to light off the ON/STANDBY indicator.

Note: When adjusting the VOLUME, be sure the “BASS” indica- tor on the Unit is lit, indicating that the subwoofer level is set to normal. If not, press the BASS CONTROL button on the Unit to light it up.

Adding the Richness to the Bass (PHASE) ——————————————

CAUTION: Be sure to turn off the POWER of the Powered Subwoofer when the Powered Subwoof- er is not in use for an extended period of time.

INPUT Terminals ——————————

The Subwoofer has the following INPUT terminals.

INPUT(LOW-LEVEL):

Usually, the LEFT/MONO terminal is connected to the SUB- WOOFER OUT terminal of the Unit with the supplied signal cord. (see page 4)

When CA-FS8000 is not used

(Using other equipment)

If an unit to be connected does not have the SUB WOOFER OUT terminals, the RIGHT and LEFT/MONO terminals will be connected to the LINE OUT-RIGHT and LEFT terminals of that unit.

LINE OUT

AMP

RIGHT LEFT

Connecting cord (not supplied)

INPUT (HIGH-LEVEL):

You can connect the speaker output terminals of other unit to these terminals.

Connect the speaker cords in parallel to the speaker terminals on the component system etc.

If you want to add the richness more to the bass, press the PHASE button to set it either in the “ _ REVERSE” position or the “ Ñ NOR- MAL” position, whichever can add the richness to the bass.

Normally, the PHASE button should be set in the “ Ñ NORMAL” position.

Automatic Operating Status On/Off

SPEAKER

RIGHTLEFT

Speaker cords (not supplied)

Component System etc.

To save energy, the Subwoofer enters the Standby mode if no (or very weak) sound signals come into the Subwoofer for about 5 min- utes. In Standby mode, the ON/STANDBY indicator of the Sub- woofer lights in red.

When sound signals come in again, the Subwoofer enters the Oper- ating mode and reproduces the sounds. The ON/STANDBY indica- tor will light in green again.

Note: Do not use the INPUT (LOW-LEVEL) terminals at the same time.

8