Troubleshooting
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person, such as your dealer, for service.
Symptom
No sound is heard.
Unable to operate the remote control.
Poor radio reception.
An inserted CD and cassette cannot be ejected.
The CD does not play.
The CD skips.
Impossible to record on a tape.
Operations are disabled.
If “CANNOT PLAY” appears on the display
If “CD LOAD ERROR” appears on the display
If “UNFINALIZE” appears on the display
Noise is heard during illumination demonstration mode.
Possible Cause
Connections are incorrect or loose.
•The path between the remote control and the remote sensor on the unit is blocked.
•The batteries have lost their charge.
•You are using the remote control far from the unit.
•The antenna is not connected correctly.
•The AM loop antenna is too close to the unit.
•The FM antenna is not properly extended and positioned.
The AC power cord is not plugged in.
The CD is upside down.
The CD is dirty or scratched.
Small tabs on the back of the cassette are removed.
The
You are trying to play back a CD which cannot be played or there is a problem with the CD.
The CD tray does not open correctly because of the obstruction.
You are trying to play back a
This unit automatically turns off and on during demonstration. If volume level is set high, you will hear this noise.
Action
Check all connections and make corrections. (See pages 6 – 9.)
•Remove the obstruction.
•Replace the batteries. (See page 6.)
•Signals cannot reach the remote sensor. Move closer to the unit.
•Reconnect the antenna securely.
•Change the position and direction of the AM loop antenna.
•Extend FM antenna to the best reception position.
Plug it in the AC power plug.
Put the CD in with the label side up.
Clean or replace the CD. (See page 35.)
Cover the holes with adhesive tape.
Unplug the unit then plug it back in.
Change the CD.
Press CD open/close 0 to close the CD tray, then remove the obstruction.
This is not a malfunction. You can play back “finalized”
Turn on the unit, decrease the volume, then turn it off again.
Specifications FS-A52 (CA-FSA52 and SP-UXA52)
Amplifier
Output Power:
40 W (20 W + 20 W) at 4 Ω (10 % THD)
Audio input sensitivity/Impedance (at 1 kHz)
LINE IN (AUX): | 500 mV/47 kΩ |
Digital output – OPTICAL DIGITAL OUT | |
Signal wave length: | 660 nm |
Output level: | |
Speaker Terminals: | 4 Ω — 16 Ω |
Tuner |
|
FM tuning range: | 87.5 MHz — 108.0 MHz |
AM tuning range: | 530 kHz — 1 710 kHz |
CD player |
|
CD capacity: | 1 CD |
Dynamic range: | 85 dB |
90 dB | |
Wow and flutter: | Immeasurable |
Casstte deck |
|
Frequency response |
|
Normal (type I): | 60 Hz — 14 000 Hz |
Wow and flutter |
|
0.15 % (WRMS) |
|
General |
|
|
Power requirement: | AC 120 V , 60 Hz | |
Power consumption: | 45 W (at operation) | |
|
| 4.3 W (on standby) |
Dimensions (approx.): |
| |
| 163 mm x 200 mm x 329 mm (W/H/D) | |
| (6 7/16 in. x 7 7/8 in. x 13 in.) | |
Mass (approx.): | 4.3 kg (9.5 lbs) | |
Speaker Section |
|
|
Speakers: | Woofer 10 cm, Tweeter 4 cm | |
Impedance: | 4 Ω |
|
Dimensions (approx.): |
| |
| 140 mm x 200 mm x 249 mm (W/H/D) | |
| (5 9/16 in. x 7 7/8 in. x 9 13/16 in.) | |
Mass (approx.): | 2.0 kg (4.5 lbs) | |
Supplied accessories
See page 6.
Design and specifications are subject to change without notice.
– 36 –
