JVC GD-V502PCE manual Setup for Input Signals, Component/RGB-in Select

Setup for Input Signals

Component/RGB-in Select

Select the input signals to be connected by installing the Optional Terminal Board. (Refer to the Operating Instructions for the optional Terminal Board.)

Select to match the signals from the source connected to the Component/RGB input terminals.

Y, PB, PR signals “Component”

R, G, B, HD, VD signals “RGB”

			INPUT
	SURROUND
			VOL
N				R
PICTURE	SOUND		SET UP
MULTI				ZOOM
PIP	SWAP	SELECT		MOVE

1
	SET UP

Press to display the Setup menu screen.

2	Press to select the “Component/RGB-in
	Select”.

Press to select the desired input signal.
Setup	1/2
Component/RGB-in select	RGB
Input label	RGB1
Signal
Screensaver
Power save	Off
Standby save	On
Power management	Off
OSD Language	English (UK)
Component	RGB
R

Press to exit from adjust mode.

Note:

Selection may not be possible, depending on which optional board is installed.

3D Y/C Filter – For NTSC AV images

Select “Signal” from the “Setup” menu during AV(S Video) input signal. (“Signal [AV]” menu is displayed.)

Press to select the “3D Y/C Filter (NTSC)”.

Press to set On/Off.

R

Press to exit from adjust mode.

Note:

When On, this setting only affects NTSC input signals.

Setup	1/2
Component/RGB-in select	RGB
Input label	RGB1
Signal
Screensaver
Power save	Off
Standby save	On
Power management	Off
OSD Language	English (UK)

Press (ACTION) button

Signal	[ AV ]
3D Y/C Filter (NTSC)	On
Colour system	Auto
Cinema reality	Off
Aspect Auto (4:3)	4 : 3

30