Power On/Off and input signal selection
Select the input signal
INPUT
Press the INPUT button to select the input signal to be played back from the equipment which has been connected to the Plasma Display.
Select the input signals to be connected by installing the optional
Terminal Boards.
Input signals will change as follows:
- +
INPUT1 INPUT2 | INPUT3 | PC IN |
INPUT MENU - VOL + ENTER
INPUT
SURROUND
VOL 
NR
Notes:
(1)Input terminal will not be selected if the terminal board is not installed into the SLOT.
(2)Select to match the signals from the source connected to the component/RGB input terminals. (see page 30)
(3)In 2 screen display, the same input mode cannot be selected for the main picture and sub picture.
Selecting the On-Screen Menu Language
SET UP
Press to display the Set Up menu.
Press to select the OSD Language.
|
| INPUT |
| SURROUND |
|
|
| VOL |
N |
| R |
PICTURE | SOUND | SET UP |
MULTI |
| ZOOM |
Press to select your preferred language.
Selectable languages
English(UK)
Deutsch
Français
Italiano
Español
ENGLISH(US)
.......(Chinese)
Setup | 1/2 |
RGB | |
| |
Input label | RGB1 |
Signal |
|
Screensaver |
|
Power save | Off |
Standby save | On |
Power management | Off |
OSD Language | English (UK) |
13
