| 18 EN VIDEO PLAYBACK |
|
| |
| Shuttle Search | Connections To A TV Or VCR | ||
Allows | |||
|
| ||
playback. |
|
| |
1) During playback, press 5 for forward search, or |
|
| |
3 for reverse search. | To S/AV |
| |
2) To resume normal playback, press 4/9. |
| ||
● During playback, press and hold 5 or 3. The search | connector | Open the cover. | |
| |||
continues as long as you hold the button. Once you release | S/AV/Editing cable | mark | |
the button, normal playback resumes. | |||
● A slight mosaic effect appears on the display during Shuttle | (provided) |
| |
|
| ||
Search. This is not a malfunction. |
|
| |
ATTENTION:
During Shuttle Search, parts of the picture may not be clearly visible, particularly on the left side of the screen.
Blank SearchHelps you find where you should start recording in the middle of a tape to avoid time code interruption.
2 Set the VIDEO/MEMORY Switch to “VIDEO”.
3 Set the Power Switch to “PLAY” while pressing down the Lock Button located on the switch.
4 Press MENU. The Menu Screen appears.
5 Press 
or 
to select “t”, and press SET. The VIDEO Menu appears.
6 Press 
or 
to select “BLANK SRCH”, and press SET. The Sub Menu appears.
7 Press 
or 
to select “EXECUTE”, and press SET.
●The “BLANK SEARCH” indication appears and the camcorder automatically starts reverse or forward search, then stops at the spot which is about 3 seconds of tape before the beginning of the detected blank portion.
●To cancel Blank Search midway, press 8.
NOTES:
●Before starting Blank Search, if the current position is at a blank portion, the camcorder searches in the reverse direction. If the current position is at a recorded portion, the camcorder searches in the forward direction.
●If the beginning or end of the tape is reached during Blank Search, the camcorder stops automatically.
●A blank portion which is shorter than 5 seconds of tape may not be detected.
●The detected blank portion may be located between recorded scenes. Before you start recording, make sure there is no recorded scene after the blank portion.
1
2
3
4
5
“Y/C”/“CVBS” | Cable Adapter* | ||
Video Out Select |
|
|
|
|
| ||
Switch |
| ||
To TV or VCR |
| ||
|
|
| TV |
VCR
A Not connected
B Black to
C Yellow to VIDEO IN (Connect when your TV/VCR has only A/V input connectors.)
D Red to AUDIO R IN** E White to AUDIO L IN**
*If your VCR has a SCART connector, use the provided cable adapter.
**Not required for watching still images only.
NOTE:
Set the video out select switch of the cable adapter as required:
Y/C: When connecting to a TV or VCR which accepts Y/C signals and uses an
CVBS: When connecting to a TV or VCR which does not accept Y/C signals and uses an audio/video cable.
1 Make sure all units are turned off.
2 Connect the camcorder to a TV or VCR as shown in the illustration.
If using a VCR, go to step 3. If not, go to step 4.3 Connect the VCR output to the TV input, referring to your VCR’s instruction manual.
4
5 Set the VCR to its AUX input mode, and set the TV to its VIDEO mode.