Set the camcorder’s Power Switch to “PLAY”.
38 EN EDITING

Dubbing To Or From A Video Unit

To use this camcorder as a player

1 Make sure all units are turned off.

Equipped With A DV Connector (Digital

2 Connect this camcorder to a video unit equipped with

Dubbing)

a DV input connector using a DV cable as shown in the

 

 

illustration.

It is also possible to copy recorded scenes from the

3 Start playback on the camcorder. ( pg. 17)

camcorder onto another video unit equipped with a DV

4 At the point you want to start dubbing, start recording

connector. Since a digital signal is sent, there is little if

on the video unit. (Refer to the video unit’s instruction

any image or sound deterioration.

manual.)

 

 

5 To stop dubbing, stop recording on the video unit, then

 

stop playback on this camcorder.

 

NOTES:

To DV IN*/OUT

Core filter DV cable (optional)

To DV IN/OUT

Video unit equipped with DV connector

* GR-D231/230 only

●It is recommended to use the AC Adapter as the power supply instead of the battery pack. ( pg. 11)

●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.

●Even though the DV cable is connected correctly, sometimes the image may not appear in step 4. If this occurs, turn off the power and make connections again.

●If “Playback Zoom” ( pg. 20) or “Playback Special Effects” ( pg. 20) is attempted or SNAPSHOT is pressed during playback, only the original playback image recorded on the tape is output from the DV IN/OUT connector.

●When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.

To use this camcorder as a recorder (GR-D231/230 only)

1 Make sure all units are turned off.

2 Connect this camcorder to a video unit equipped with a DV output connector using a DV cable as shown in the illustration.

3 Set “REC MODE” to “SP” or “LP”. ( pg. 27)

4

5 Press the Recording Start/Stop Button to engage the Record-Pause mode.

●The “ DV. IN ” indication appears on the screen.

6 Start playback on the player.

7 At the point you want to start dubbing, press the Recording Start/Stop Button to start dubbing. The indication rotates.

8 Press the Recording Start/Stop Button again to stop

dubbing. The indication stops rotating.

NOTES:

●If no image is displayed on the LCD monitor, set “S/AV INPUT” to “OFF”. ( pg. 27, 30)

●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting. ( pg. 27)