JVC GR-D350EW Loading/Unloading A Cassette, OPEN/EJECT, To protect valuable recordings

			GETTING STARTED EN 17
Loading/Unloading A Cassette			● Once the cassette holder is closed, it recedes
			automatically. Wait until it recedes completely
The camcorder needs to be powered up to load			before closing the cassette holder cover.
			● When the battery pack’s charge is low, you may
or eject a cassette.
			not be able to close the cassette holder cover. Do
	Cassette holder		not apply force. Replace the battery pack with a
PUSH	cover		fully charged one or use AC power before
			continuing.
OPEN/EJECT
			3 Close the cassette holder cover firmly until it
			locks into place.
			To protect valuable recordings
			Slide the erase protection tab on the back of the
			tape in the direction of “SAVE”. This prevents the
			tape from being recorded over. To record on this
			tape, slide the tab back to “REC” before loading
Cassette holder		Erase	it.
			NOTES:
		protection tab
Make sure the window side
			● If you wait a few seconds and the cassette holder
is facing out.			does not open, close the cassette holder cover
1 Slide and hold OPEN/EJECT in the direction			and try again. If the cassette holder still does not
			open, turn the camcorder off then on again.
of the arrow, then pull the cassette holder cover			● If the tape does not load properly, open the
open until it locks. The cassette holder opens			cassette holder cover fully and remove the
automatically.			cassette. A few minutes later, insert it again.
● Do not touch internal components.			● When the camcorder is suddenly moved from a
2 Insert or remove a tape and press “PUSH” to			cold place to a warm environment, wait a short

close the cassette holder. time before opening the cassette holder cover.

●Be sure to press only the section labelled “PUSH” to close the cassette holder; touching other parts may cause your finger to get caught in the cassette holder, resulting in injury or product damage.

GETTING STARTED