Dubbing Still Images Recorded On A Tape To A Memory Card

Still images can be dubbed from a tape to a memory card.

1 Load a cassette. ( pg. 10)

2 Load a memory card. ( pg. 10)

3 Set the VIDEO/MEMORY Switch to “VIDEO”.

4 Set the Power Switch to “PLAY” while pressing down the Lock Button located on the switch.

5 Set “ COPY” to “ON”. ( pg. 25, 28)

6 Press 4/9 to start playback.

7 At the point you want to dub, press 4/9 again to engage Still Playback.

8 To dub the image, press SNAPSHOT.

●The “ ” indication appears during dubbing.

●The selected image is stored in the memory card.

NOTES:

●If SNAPSHOT is pressed in step 8 when a memory card is not loaded, the message “COPYING FAILED” is displayed.

●If an image recorded on the tape using “WIDE MODE”

( pg. 26) is dubbed to a memory card, the WIDE mode identifying signal is not dubbed with it.

●To use Playback Special effects with a video image you wish to dub, perform up to step 8 using the remote control (provided). ( pg. 16)

●Images are dubbed in 640 x 480 pixels.