58 EN
PLAY (
4
)
STOP (5)
Dubbing To A Video Unit Equipped With ADV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.

[To use this camcorder as a player]

1
Make sure all units are turned off. Connect the
camcorder to a video unit equipped with a DV input
connector using a DV cable as shown in the illustration.
2
Set the camcorder’s Power Switch to “ ” while
pressing down the Lock Button located on the switch,
turn on the video unit’s power, and insert the
appropriate cassettes in the camcorder and the video
unit.
3
Press
4
to play back the source tape.
4
While watching the playback on the monitor, engage
the DV connector-equipped video unit’s record mode
from the spot on the source tape you want to begin
recording.
NOTES:
●
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery pack
(
pg. 7).
●
If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press
the buttons on both units.
●
For Digital Dubbing, this camcorder can be connected
only to one device at a time.
●
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
●
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 4. If this
occurs, turn off the power and make connections again.
●
If “Playback Zoom” (
pg. 63), “Playback Special
Effects” (
pg. 64) or “Snapshot” is attempted during
playback, only the original playback image recorded on
the tape is output from the DV OUT connector.
●
When using a DV cable, be sure to use the optional JVC
VC-VDV204U DV cable.
DV cable
(optional)
Video unit
equipped with DV
input connector
To DV IN
To DV OUT
Power Switch
Core filter
Core filter
DUBBING
(cont.)