72 EN | USING THE REMOTE CONTROL UNIT (cont.) |
Display | Insert Editing |
6w
12 : 34
Power Switch
Lock Button
Remote sensor
START/STOP
INSERT
REW
PLAY
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.
NOTES:
●Before performing the following steps, make sure that
“TIME CODE” is set to “ON” in the Menu Screen ( pg. 39).
●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
●To perform Insert Editing while watching in the television, make connections ( pg. 52).
1 Play back the tape, locate the
2
3 Press and hold INSERT (w) on the remote control, then press PAUSE (6). “6w” and the Time Code (min.:sec.) appear and the camcorder enters Insert- Pause mode.
4 Press START/STOP to begin editing.
•Confirm the insert at the time code you checked in step 1.
•To pause editing, press START/STOP. Press it again to resume editing.
5 To end Insert Editing, press START/STOP, then STOP (5) on the remote control. Do not press the Stop button (5) on the camcorder since this will activate backlight compensation instead.
NOTES:
● Programme AE with special effects ( pg. 34, 35) can |
be used to spice up the scenes being edited during Insert |
Editing. |
● During Insert Editing, the date and time information |
changes. |
● If you perform Insert Editing onto a blank space on the |
STOP
PAUSE
tape, the audio and video may be disrupted. Make sure |
you only edit recorded areas. |
● During Insert Editing, when the tape moves to scenes |
recorded in the LP mode or a blank portion, Insert Edting |
stops ( pg. 87). |
