JVC GR-DVL725, GR-DVL725U 10 EN, Grip Adjustment, Tripod Mounting, Viewfinder Adjustment, Shoulder Strap Attachment, GETTING STARTED (cont.), CAUTION

Separate the Velcro strip.

10 EN GETTING STARTED (cont.)

Power

Zoom Lever

Recording Start/

Stop button

Power Switch

Diopter

Adjustment Control

PAUSE

Grip Adjustment

1

2 Pass your right hand through the loop and grasp the grip.

3 Adjust your thumb and fingers through the grip, to easily operate the Recording Start/Stop button and Power Switch and Power Zoom Lever. Be sure to fasten the Velcro strip to your preference.

Viewfinder Adjustment

1 Set the Power Switch to “	” or “	”
AUTO	MANUAL

while pressing down the Lock Button located on the switch.

2 Turn the Diopter Adjustment Control until the indications in the viewfinder are clearly focused.

	Shoulder Strap Attachment
	1 Make sure the battery pack is removed. Following
2	the illustration, thread the strap through the eyelet 1,
	then fold it back and thread it through the buckle 2.
	Repeat the procedure to attach the other end of the
1	strap to the other eyelet 3 located under the Grip
	Strap . Confirm the strap is not twisted.

3

Tripod MountingCAUTION

When attaching the camcorder to a tripod, extend its legs to stabilize the camcorder. It is not advised to use small sized tripods. This may cause damage to the unit by falling over.

1 To attach the camcorder to a tripod, align the direction stud and screw to the mounting socket and stud hole on the camcorder. Then tighten the screw clockwise. Some tripods are not equipped with studs.