JVC GR-DVL915, GR-DVL510, GR-DVL515, GR-DVL310, GR-DVL715, GR-DVL410 specifications 54 EN, Dubbing

54 EN

VIDEO/DSC Switch (GR-DVL915/DVL715/DVL515 only)

To DV

Core filter	Lock Button
				OFF
			Y
		A
	P	L
DV cable
(optional)	Power Switch

Core filter

To DV

IN/OUT

Video unit equipped with DV connector

DUBBING (cont.)

Dubbing To Or From A Video Unit Equipped With A DV Connector (Digital Dubbing)

It is also possible to copy recorded scenes from the camcorder onto another video unit equipped with a DV connector. Since a digital signal is sent, there is little if any image or sound deterioration.

[To use this camcorder as a player]

1 Make sure all units are turned off. Connect the camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.

2 Set the VIDEO/DSC Switch to “VIDEO” (GR-DVL915/DVL715/DVL515 only), set the

camcorder’s Power Switch to “ ” while pressing down the Lock Button located on the switch, turn on the video unit’s power, and insert the appropriate cassettes in the camcorder and the video unit.

3 Press 4to play back the source tape.

4 While watching the playback on the monitor, engage the DV connector-equipped video unit’s record mode from the spot on the source tape you want to begin recording.

NOTES:

●It is recommended to use the AC Adapter as the power supply instead of the battery pack (
pg. 9).

●If the remote control is used when both the player and recorder are JVC video units, both units will perform the same operation. To prevent this from happening, press the buttons on both units.

●If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so that an unusual image is not dubbed.

●Even though the DV cable is connected correctly, some- times the image may not appear in step 4. If this occurs, turn off the power and make connections again.

●If “Playback Zoom” (
pg. 60), “Playback Special Effects” (
pg. 59) or “Snapshot” is attempted during playback, only the original playback image recorded on the tape is output from the DV connector.

●When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.

To Use This Camcorder As A Recorder . . .

1.Set the VIDEO/DSC Switch to “VIDEO” (GR-DVL915/DVL715/DVL515 only), then set the Power Switch

to “ ” while pressing down the Lock Button located on the switch.

2.Set “REC MODE” to “SP” or “LP” in the Menu Screen (
pg. 50)

3.Connect the DV cable as shown in the illustration and load a cassette to record on.

4.Press the Recording Start/Stop button to engage the Record-Pause mode. “ DV. IN ” appears on the screen.

5.Press the Recording Start/Stop button to start recording. rotates.

6.Press the Recording Start/Stop button again to engage the Record-Pause mode. stops rotating.

NOTES:

●Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current “SOUND MODE” setting (
pg. 47).

●During Digital Dubbing, no signals are output from the video or audio connectors.