JVC GR-DVL510, GR-DVL515, GR-DVL310, GR-DVL715 EN67, Insert Editing GR-DVL915/DVL715/DVL515 only

Play back the tape, locate the Edit-Out point and press PAUSE (6). Confirm the time code at this point ( pg. 51).

Press REW (2) until the Edit-In point is located, then press PAUSE (6).

Lock Button

Power Switch

Display

6w

12 : 34

Remote sensor

T W START/STOP

INSERT

REW PLAY

STOP

PAUSE

EN67

Insert Editing (GR-DVL915/DVL715/DVL515 only)

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.

NOTES:

●Before performing the following steps, make sure that

“TIME CODE” is set to “ON” in the Menu Screen (  pg. 50).

●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Insert Editing while watching in the television, make connections (  pg. 22).

1

2

3 Press and hold INSERT (w) on the remote control, then press PAUSE (6). “6w” and the Time Code (min.:sec.) appear and the camcorder enters Insert- Pause mode.

4 Press START/STOP to begin editing.

•Confirm the insert at the time code you checked in step 1.

•To pause editing, press START/STOP. Press it again to resume editing.

5 To end Insert Editing, press START/STOP, then STOP (5).

NOTES:

●Programme AE with special effects ( pg. 38, 39) can be used to spice up the scenes being edited during Insert Editing.

●During Insert Editing, the date and time information changes.

●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

●During Insert Editing, when the tape moves to scenes

recorded in the LP mode or a blank portion, Insert Edting stops (  pg. 84).