EN 65
Audio Dubbing
The audio track can be customized only when recorded on the 32 kHz mode (☞ pg. 35).
NOTE:
Audio Dubbing is not possible on a tape recorded at 48 kHz, on a tape recorded in the LP mode or on a blank portion of a tape.
6e
Remote sensor |
| External microphone |
MIC | input connector | |
|
| (Located beneath |
|
| the cover.) |
Stereo microphone |
|
|
|
|
Audio Dub Standby
Power Dial
Speaker
T W
DISPLAY 
AUDIO 
MONITOR 
A.DUB
PLAY
PAUSE
STOP
1 FIND EDIT-IN POINT
Play back the tape to locate the point where editing will start, then press PAUSE.
2 ENGAGE AUDIO DUB STANDBY While holding A. DUB on the remote control, press PAUSE. “6e” appears.
NOTES:
3 BEGIN DUBBING
Press PLAY, then begin “narrating”.
•Speak into the microphone.
4 PAUSE DURING DUBBING
Press PAUSE.
5 STOP DUBBING
Press STOP.
●Audio dubbing is possible using an optional microphone connected to the external microphone input connector (MIC).
●While an optional microphone is connected, the
●When editing onto a tape that was recorded at 32 kHz, the old and new soundtracks are recorded separately.
●To select the desired sound for playback, press AUDIO MONITOR on the remote control.
●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.
●If feedback or howling occurs during TV Playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.
●Sound is not heard from the speaker during Audio Dubbing. To hear sound, connect optional headphones to the
●If you change from 32 kHz to 48 kHz in
●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded at 48 kHz or a blank portion, Audio Dubbing stops and “ERROR! REFER MANUAL” appears.
RECORDING SOUND | DISPLAY | OUTPUT SOUND |
32 kHz | FULL SOUND | Original and new tracks are combined and output in stereo. |
| SOUND 2 | New track is output on both “L” and “R” channels in stereo. |
| SOUND 1 | Original track is output on both “L” and “R” channels in stereo. |
|
|
|
