WARNING INDICATIONS
(high) | (exhausted) |
Displays the battery remaining power level. As the battery power comes close to nil, the battery indicator
blinks (battery power warning). When the battery power is exhausted, power turns off automatically.
Appears when no tape is loaded.( pg. 9)
CHECK TAPE’S ERASE PROTECTION TAB
Appears when the erase protection tab is set to “SAVE” while the Power Switch 8 is set to “ ” or “ 
”.
( pg. 9)
HEAD CLEANING REQUIRED USE CLEANING CASSETTE
Appears if dirt is detected on the heads during recording or playback. Use an optional cleaning
cassette. | ( pg. 38) |
CONDENSATION, OPERATION PAUSED PLEASE WAIT
Appears if condensation occurs. When this indication is displayed, wait more than 1 hour until condensation disappears.
TAPE!
Appears if a tape is not loaded when the Recording Start/Stop Button 7 or SNAPSHOT Button 5 is pressed while the Power Switch 8 is set to “ ” or “ 
”.
TAPE END
Appears when the tape ends during recording or playback.
SET DATE/TIME! |
|
• Appears when the date/time is not set. | ( pg. 10) |
•Appears when the
( pg. 38)
LENS CAP
Appears for 5 seconds after power is turned on if the lens cap is attached.
A. DUB ERROR!
Appears if Audio Dubbing is attempted on a blank
portion of a tape. | ( pg. 29) |
A. DUB ERROR!
<CANNOT DUB ON A LP RECORDED TAPE> <CANNOT DUB ON A 16BIT RECORDING> <CHECK TAPE’S ERASE PROTECTION TAB>
•Appears if Audio Dubbing is attempted on a tape recorded in the LP mode.
•Appears if Audio Dubbing is attempted on a tape recorded in
•Appears if A. DUB (e) h on the remote control is pressed when the erase protection tab is set to
“SAVE”.( pg. 29)
INSERT ERROR!
Appears if Insert Editing is attempted on a blank
portion of a tape. | ( pg. 29) |
INSERT ERROR!
<CANNOT EDIT ON A LP RECORDED TAPE> <CHECK TAPE’S ERASE PROTECTION TAB>
•Appears if Insert Editing is attempted on a tape recorded in the LP mode.
•Appears if INSERT (w) g on the remote control is
pressed when the erase protection tab is set to
“SAVE”. | ( pg. 29) |
E01, E02 or E06 UNIT IN SAFEGUARD MODE REMOVE AND REATTACH BATTERY
The error indications (E01, E02 or E06) show what type of malfunction has occured. When an error indication appears, the camcorder turns off automatically. Remove the power supply (battery, etc.) and wait a few minutes for the indication to clear. When it does, you can resume using the camcorder. If the indication remains, consult your nearest JVC dealer.
E03 or E04 UNIT IN SAFEGUARD MODE EJECT AND REINSERT TAPE
The error indications (E03 or E04) show what type of malfunction has occured. When an error indication appears, the camcorder turns off automatically. Eject the cassette once and
EN
