JVC GR-FXM45 specifications Tape Dubbing

Basic Connections

1 CONFIRM POWER-OFF STATUS Make sure the camcorder’s power is off.

2 CONNECTVCR CAMCORDER TO TV OR

Pull out the connector cover and open it. Connect as shown in the illustration (☞ pg. 42).

If using a VCR . . . go to step 3.

If not . . . go to step 4.

3 CONNECTINPUT VCR OUTPUT TO TV

Refer to your VCR’s instruction manual.

4 SUPPLY POWER

Turn on the camcorder, the VCR and the TV.

5 SELECT MODE

Set the VCR to its AUX input mode, and set the TV to its VIDEO mode.

NOTES:

●It is recommended to use the AC Power Adapter/

Charger as the power supply instead of the battery pack (☞ pg. 7).

●To monitor the picture and sound from the camcorder without inserting a tape, set the camcorder’s Power Switch to “CAMERA” (“AUTO” or “PRO.”), then set your TV to the appropriate input mode.

●Make sure you adjust the TV sound volume to its minimum level to avoid a sudden burst of sound when the camcorder is turned on.

●If you have a TV or speakers that are not specially shielded, do not place the speakers adjacent to the TV as interference will occur in the camcorder playback picture.

EN43

Tape Dubbing

1 CONNECT EQUIPMENT

Following the illustration on pg. 42, connect the camcorder and the VCR.

2 PREPARE FOR DUBBING

Set the camcorder’s Power Switch to “PLAY”, turn on the VCR’s power, and insert the appropriate cassettes in the camcorder and the VCR.

3 SELECT VCR MODE

Engage the VCR’s AUX and Record-Pause modes.

4 FIND EDIT-IN POINT

Engage the camcorder’s Play mode to find a spot just before the edit-in point. Once it is reached, press PLAY/PAUSE (4/6) on the camcorder.

5 START EDITING

Press PLAY/PAUSE (4/6) on the camcorder and engage the VCR’s Record mode.

6 STOP EDITING TEMPORARILY Engage the VCR’s Record-Pause mode and press PLAY/PAUSE (4/6) on the camcorder.

7 EDIT MORE SEGMENTS

Repeat steps 4 through 6 for additional editing, then stop the VCR and camcorder when finished.