JVC GR-FXM75 manual Built-in Memory Onto a Tape, Select Still Image

Power Switch

System Select Switch

EN63

Insert Editing (Insert A Still Image From

The Built-in Memory Onto A Tape)

You can insert a still image stored in the camcorder's built- in memory into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

Perform steps 1 through 5 in Insert Editing (VIDEO) (☞ pg. 62) before the following procedure.

NOTE:

REW (2/PAGE–) Button

FF (3/PAGE+) Button PLAY/PAUSE (4/6) Button

STOP (5) Button

COUNTER R/M Button

Display

Insert editing indicator

M 0 : 12 : 34 Tape counter

Remote sensor

START/STOP

PAUSE

REW STOP

PLAY INSERT

RM-V709U (provided)

Use the RM-V709U remote control unit to perform this procedure.

1 SELECT STILL IMAGE

First set the System Select Switch to “D.S.C.”. Press REW (2/PAGE–) or FF (3/PAGE+) to select the still image you wish to insert.

2 BEGIN INSERT EDITING

Press START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode.

To insert still images in sequential order onto the tape . . .

... press REW (2/PAGE–) or FF (3/PAGE+) to move the page forward.

To insert still images at random onto the tape . . .

... first record the still image you selected in step 1 onto the tape, then press START/STOP to engage the Insert-Pause mode. To select another still image, press REW (2/PAGE–) or FF (3/ PAGE+) again, then press START/STOP. Insert- Editing begins.

3 END INSERT EDITING

Press STOP.

NOTES:

●The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.

●Only video signal is recorded in the Insert Editing mode.