|
|
|
|
|
| EN43 | |
Original tape (camcorder) |
| AUTOMATIC EDITING TO VCR | |||||
| 1 | 3 | 2 |
|
|
| |
|
| Rewind the tape in the camcorder to the beginning of | |||||
|
|
|
|
|
| ||
|
| IN | OUT IN OUT | IN OUT 9 the scene you want to edit and press PAUSE (6). | |||
|
|
|
|
|
|
|
|
10 Point the remote control towards the VCR’s infrared sensor and press VCR REC STBY (q6), or manually engage the VCR’s
Edited tape (VCR)
STOP (5) Button
REW (2) Button
PAUSE (6) Button
Power Switch
Recording Start/Stop Button
11 Press the Recording Start/Stop Button on the camcorder to begin Automatic Editing, and the previously selected scenes are copied to the VCR in the specified order.
While editing, the R.A. Edit counter of the scene which is being copied is shown with a blinking highlight.
•Pressing START/STOP on the remote control does not start editing.
12 When all selected scenes have been copied, the camcorder and VCR enter the Still or Pause mode. Press STOP (5) on both units. To make the R.A. Edit counter display disappear, press R.A.EDIT ON/OFF.
•When finished editing, be sure to disconnect the editing cable and the A/V cable.
NOTES:
●If you performed step 1 
on page 41 (“MAKE CONNECTIONS”), keep the remote control pointed at the VCR during editing.
●The on-screen display only appears while the camcorder searches for each scene.
●There may be noise at in- or out-points on the edited tape with certain VCRs.
Remote Sensor
PAUSE
VCR REC STBY
R.A.EDIT
ON/OFF