NOTES:

Charging times are for a fully discharged battery pack.

When the battery/CF card cover is opened or the SD card is removed while the power is on, the power is automatically turned off to protect the data in the recording medium. To turn on the power again after opening the battery/CF card cover, close the cover. To turn on the power again after removing the SD card, close the cover and set the power switch to OFF, then to or .

It is recommended that only genuine JVC batteries are used in this camera. Using generic non-JVC batteries can cause damage to the internal charging circuitry.

If the protective cap is attached to the battery pack, remove it first.

When charging the battery pack for the first time or after a long storage period, the power/charge lamp may not light. In this case, remove the battery pack from the camera, then try charging again.

If the battery operation time remains extremely short even after having been fully charged, the battery is worn out and needs to be replaced.

Please purchase a new one.

Using the optional AA-V200 battery charger, you can charge the BN-VM200U battery pack without the camera.

Since the AC adapter processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

Using the Battery Pack

Perform steps 2 4 in “Charging the Battery Pack”.

Maximum continuous recording time

Battery pack

Recording time

 

 

BN-VM200U (provided)

1 hr.

 

 

NOTES:

Recording time is reduced significantly under the following conditions:

Zoom or record-standby mode is engaged repeatedly.

Playback mode is engaged repeatedly.

Before extended use, it is recommended that you prepare enough battery packs to cover 3 times the planned recording time.

 

GETTING STARTED EN 15

 

Using AC Power

 

 

Connect the AC adapter to the camera.

 

Open the cover.

 

STARTED

To DC

mark

GETTING

connector

 

 

 

To AC outlet

 

AC Adapter

(ex. AP-V17E)

NOTE:

The provided AC adapter features automatic voltage selection in the AC range from 110 V to 240 V.

ATTENTION:

Before detaching the power source, make sure that the camera’s power is turned off. Failure to do so can result in a camera malfunction.

If the camera is a subject to electrostatic discharge, turn the power off before using it again.

About Batteries

DANGER! Do not attempt to take the batteries apart, or expose them to flame or excessive heat, as it may cause a fire or explosion. WARNING! Do not allow the battery or its terminals to come in contact with metals, as this can result in a short circuit and possibly start a fire.

The Benefits of Lithium-Ion Batteries

Lithium-ion battery packs are small but have a large power capacity. However, when one is exposed to cold temperatures (below 10°C), its usage time becomes shorter and it may cease to function. If this happens, place the battery pack in your pocket or other warm, protected place for a short time, then re-attach it to the camera.