JVC HR-A32U, HR-A52U, HR-A52U(Hi-Fi) instruction manual Timer Recording

							31
TIMER RECORDING
		SYMPTOM		POSSIBLE CAUSE		CORRECTIVE ACTION
1.	Timer recording won’t work.		● The clock and/or the timer have		Check or re-perform the clock/timer
			been set incorrectly.		settings to ensure correctness.
			● The timer is not engaged.		Press TIMER and check to make sure
					that the Timer indicator on the front
					panel lights.
			● The VCR has not been set up properly.		Re-perform the set-up procedures.
2.	On-screen timer programming		● Timer recording is in progress.		Timer programming can’t be performed
	won’t work.				when timer recording is in progress.
					Wait until it finishes.
3.	The Timer indicator on the front of		● The timer is engaged but there’s no		Load a cassette with the record safety
	the VCR won’t stop blinking.		cassette loaded.		tab intact, or with the hole covered
					with adhesive tape.
4.	The cassette is automatically		● The loaded cassette has had its		Remove the cassette and cover its
	ejected, and the Timer indicator on		record safety tab removed.		hole with adhesive tape, or replace it
	the front of the VCR won’t stop				with a cassette on which the safety
	blinking.				tab is intact.
5.	The Timer indicator on the front of		● TIMER has been pressed when there		Check the programmed data and re-
	the VCR blinks for 10 seconds and		are no programs in memory, or the		program as necessary, then press
	the timer mode is disengaged.		timer record program information		TIMER again.
			has not been programmed correctly.
6.	The cassette is automatically		● The end of tape was reached during		The program may not have been
	ejected, the power shuts off and the		timer recording.		recorded in its entirety. Next time
	Timer indicator on the front of the				make sure you have enough time on
	VCR won’t stop blinking.				the tape to record the entire program.
OTHER PROBLEMS
		SYMPTOM		POSSIBLE CAUSE		CORRECTIVE ACTION
1.	When scanning channels, some of		● Those channels have been preset to		If you need the skipped channels,
	them are skipped over.		be skipped.		restore them (☞ pg. 11).
2.	The channel can’t be changed.		● Recording is in progress.		Press PAUSE to pause the recording,
					change channels, then press PLAY to
					resume recording.

ATTENTION:

This recorder contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the power off and unplug the power cord. Then plug it in again and switch power on. Take out the cassette. After checking the cassette, operate the unit as usual.