8 EN
VideoChannel Set
INITIAL SETTINGS (cont.)
Video Channel (RF Output Channel) is the channel on
which your TV receives picture and sound signals from the
video recorder through the RF cable.
123
456
789
0
2
4
1
3
?
OK
If you have connected the video recorder to your TV via
the RF cable only (RF connection) you have to set the
correct video channel – Go to "With RF Connection"
below.
If you have connected the video recorder to your TV
via both the RF cable and a 21-pin SCART cable (AV
connection), since you do not need the video channel
you have to set the video channel to off – Go to "With
AV Connection" on next page.
IMPORTANT:
Before performing the following steps, make sure the
recorder's power is off and there is no cassette inserted in
the recorder.

ACCESS VIDEO CHANNEL

SET MODE

1
Hold down STOP on the recorder until the display
panel shows the following.

SET VIDEO CHANNEL

2
Set your TV to UHF channel 36.
●If the two vertical white bars appear clearly on the
screen as shown in the illustration at bottom left, go
to step 3.
●If the two vertical white bars do not appear clearly,
press TV PROG + or – to set the video recorder to a
vacant channel between 28 and 60 which is not
occupied by any local station in your area.
Then set your TV to UHF channel 50 and check if the
two vertical white bars appear clearly on the screen; if
so, go to step 3. If not, re-set the video recorder to
another vacant channel and try again.
NOTES:
●
If you set the video recorder to a channel which isoccupied by a local station or has neighbouringchannels that are occupied by local stations, thepicture reception quality will be affected and someinterference noise will appear on the TV screen. Besure to select a vacant channel which has nobroadcast on neighbouring channels.
●
If you cannot obtain the two vertical white barsclearly with any channel between 28 and 60, consultyour JVC dealer.

EXIT VIDEO CHANNEL SET

MODE
3
Press OK.

With RF Connection

(Ex.) If channel 50 is available in your area
TEST SIGNAL
The channel on which the screen to
the left appear clearly in step 2 is
your Video Channel.
To view picture signals from the video recorder, set your
TV to the Video Channel.
STOP
TV PROG
TV PROG