subsidiary information
SYMPTOM | POSSIBLE CAUSE | CORRECTIVE ACTION |
51
OTHER PROBLEMS
1.Whistling or howling is heard from the TV during camcorder recording.
2.When scanning channels, some of them are skipped over.
3.The preset cannot be changed.
¥The camcorderÕs microphone is too close to the TV.
¥The TVÕs volume is too high.
¥Those channels have been designated to be skipped.
¥Recording is in progress.
Position the camcorder so its microphone is away from the TV. Turn the TVÕs volume down.
If you need the skipped channels, restore them.
Press to pause the recording, change presets, then press to resume recording.
4.Channel settings that were made manually seem to have changed or disappeared.
5.No channels are stored in the VCRÕs memory.
¥After the manual settings were made, Auto Channel Set was performed.
¥The TV aerial cable was not connected to the VCR when Plug&Play Setup was per- formed.
Perform manual setting again.
Turn off the VCR once and connect the TV aerial cable to the VCR properly, plug the main power cord into a main outlet again. Then perform Plug&Play Setup again (☞Êpg.Ê10).
