JVC HR-J795EK Display Tape Remaining Time, Change Display Information, Resetting the Counter

TV/VCR AU

2

O – –:– –

3

TV

TV/VCR AUDIO – –:– –

1	2			3
				2
4	5			6
VPS/PDC	DAILY/QTDN. WEEKLY/HEBDO
7	8			9
0000	AUX			4
	0
START	STOP	DATE		PR
DEBUT	FIN
	EXPRESS
1 PROG	?			30 SEC
		ENTER/ENTREE
MENU		PR	3	OK
	TV		+
T				+
V
–				TV
	TV PR		–

7

0000

TE PR

basic features 19

Notes on Recording

When using both the RF and SCART connections, you can switch between TV and VCR by pressing the TV/VCR button on the Remote Control.

If the tape reaches its end during recording, the recording stops and “U” and

“,” on the display panel blink. Press S/0on the VCR to eject the tape or press

<to rewind the tape.

Display Tape Remaining Time

Press the bbutton so that the tape remaining time is shown on the TV screen with ‘REMAIN’ indication. The on-screen information will disappear after about 5 seconds.

non-standard tapes Sometimes, a tape will not conform to the standards accepted by this VCR. In such cases the tape remaining time may not appear immediately, be incorrect or simply show as ‘– – : – –’.

Change Display Information

By pressing the bbutton repeatedly, you can change the display on the VCR between the clock time and the preset position. The preset position cannot be shown during playback.

Resetting the Counter

Press the bbutton so that the counter display appears on the TV screen. While the display is shown, press the 0000 button. You can reset the counter to ‘0:00:00’ before starting playback or recording.

Record a Programme While Watching Another

Once you have started recording all you need to do is use the controls on your TV set to tune to a different programme. The programme set using the PR button on the Remote Control or the JOG Dial on the VCR is the one which will be recorded.