Filename [HRJ870EU3.fm]
Masterpage:Left
46 EN
Page 46 July 11, 2000 3:50 pm
EDITING (cont.)
Synchro Editing The Synchro Editing function synchronizes the start of the
playback and recording operations when starting an edit
operation using a camcorder with LANC connector and your
recorder.
AMake connections.

Connect your recorder to camcorder (墌pg.4 5), and

connect your recorder’s SYNCHRO EDIT connector to

the camcorder’s LANC connector.

BSet the recorder’s input mode.
Press AUX (number key “0”) and/or PR to select “F-1”.
CSet the edit mode.

See “PICTURE CONTROL” on page 57.

DLocate the start point.

Start playback of the tape in the camcorder, and pause

playback when you find the point where you want to start

editing. Press and hold 9 and press 7 on your recorder

so that the recorder enters the Record-Pause mode.

EStart Synchro Editing.

Press SYNCHRO 7/79.

FPause Synchro Editing.

Press SYNCHRO 7/79 again.

●Repeat steps 4 – 6 as necessary.
NOTES:
●The Synchro Editing function may not work with the initial part
of a camcorder tape.
●The Synchro Editing function cannot be used when using the
JLIP function. (Pressing SYNCHRO
7
/
79
cancels the JLIP
function.)
●The Synchro Editing function may not work properly with
some type of camcorder.
●When you select “EDIT” to dub tapes in step 3, be sure to
select “AUTO” (or “NORM” when “B.E.S.T.” is set to “OFF”)
after you finish dubbing the tapes.
Recorder
Player
LANC cable
(not provided)
SYNCHRO EDIT
connector
Camcorder To LANC connector
HRJ870EU3.fm Page 46 Tuesday, July 11, 2000 4:00 PM