JVC HR-S7850EU, HR-S7851EU 56 EN, Function  pg , set PROG. Navigation to OFF, For Example

56 EN		SUBSIDIARY SETTINGS (cont.)
		* The default setting is bold in the table below.
8 PROG. NAVIGATION	When this function is set to “ON”, the recorder stores information on the
ON	recorded programmes. If you do not want to use the Programme Navigation
OFF	function ( pg. 38), set “PROG. NAVIGATION” to “OFF”.
	NOTES:
	● Programme Navigation is possible with the cassettes recorded with this recorder
	only.
	● Before recording, make sure the recorder’s clock is set correctly.
	● To record the programme information in this recorder’s memory, you must continue
	to record each programme for over the minimum recording time; 8 minutes for the
	SP mode, 15 minutes for the LP mode or 23 minutes for the EP mode.
	● Programme Navigation may not work properly depending on the tape being used.
	● The programme information is stored in this recorder’s memory. If the memory in this
	recorder should ever be damaged and the programme information lost, it is
	impossible to restore that information.
8 DIRECT REC	When this function is set to “ON”, you can easily start recording the
ON	programme that you are watching on your TV. Press and hold 7 and press 4
OFF	on the remote control, or press 7 on the recorder.
	NOTES:
	● When you use the Direct Rec function, be sure to use a TV offering T-V LINK, etc.
	and connect a fully-wired 21-pin SCART cable between the recorder and the TV
	( pg. 10).
	● If “DIRECT REC” is set to “OFF”, the 7 button functions as described in “Basic
	Recording” ( pg. 24).
	● During the Direct Rec, “– –” appears on the front display panel.
	● Retake function ( pg. 26) does not work during Direct Rec.
8 AUTO SP]LP TIMER	When this function is set to “ON”, the recorder automatically switches to LP
ON	mode to allow complete recording if there is not enough tape to record the
OFF	entire programme while timer-recording in SP mode.
	For Example . . .
	Recording a programme of 210 minutes in length onto a 180-minute tape
	Approximately 150 minutes	Approximately 60 minutes
	SP mode	LP mode
	Total 210	minutes
	Make sure you set this function to “ON”, before the timer-recording starts.
	NOTES:
	● If you have programmed the recorder to timer-record 2 or more programmes, the
	second programme and those thereafter may not fit on the tape if you set “AUTO
	SP]LP TIMER” to “ON”. In this case, make sure the mode is not engaged, then set
	the tape speed manually during timer programming.
	● In order to ensure that the recording fits on the tape, this feature may leave a slight
	non-recorded section at the end of the tape.
	● There may be some noise and sound disturbance at the point on the tape where the
	recorder switches from SP to LP mode.
	● The Auto SP]LP Timer feature is not available during ITR (Instant Timer Recording),
	and the feature will not work properly with any tapes longer than E-180, or with
	some tapes of shorter lengths.
	● If you perform timer recording with both VPS/PDC and the Auto SP]LP Timer
	activated, and the programme goes beyond its originally scheduled length, there
	may be times when the programme cannot be recorded in its entirety.