JVC HR-S7851EU, HR-S7850EU Another Video Recorder, Advantages of S-VHS video recorders

EN 43

Edit To Or From

Another Video

Recorder

A
TV receiver		Player	Your recorder
		21-pin SCART cable
		(not provided)
Video	RF cable
channel or	(provided)
AV mode
		Another recorder
		Recorder
B
Recorder		Your recorder	TV receiver
21-pin SCART cable
	(not provided)
		RF cable		Video
		(provided)		channel or
				AV mode
Another recorder
Player

Advantages of S-VHS video recorders

You can edit from VHS to S-VHS, S-VHS to VHS, or, from S-VHS to S-VHS.

●From VHS to S-VHS: Record VHS playback signals in the S-VHS mode. Although the picture quality is inherently limited by that of the original, the edited tape has better picture quality than those made by VHS-to-VHS editing.

●From S-VHS to VHS: Because the picture quality of the source material is very high, the edited tape has better picture quality than those made by VHS-to-VHS editing.

●From S-VHS to S-VHS: All signals will be transferred with minimum degradation.

You can use your recorder as the source player or as the recording deck.

A Make connections.

Connect the player’s 21-pin SCART connector to the recorder’s 21-pin SCART connector as illustrated.

AWhen using your recorder as the source player ...

... connect its AV1 (L-1) IN/OUT connector to the recording deck.

BWhen using your recorder as the recording deck ...

... connect its AV1 (L-1) IN/OUT or AV2 (L-2) IN/

DECODER connector to the source player.

●If another recorder is compatible with the Y/C signal ...

... when using your recorder as the source player, set “L-1 OUTPUT” to “S-VIDEO” ( pg. 44).

... when using your recorder as the recording deck, set “L-2 INPUT” to “S-VIDEO” ( pg. 45).

B Set the input mode of recording deck.

With this video recorder, press AUX (number key “0”) and/or PR to select “L-1” for the AV1 (L-1) IN/OUT connector, or “L-2” for the AV2 (L-2) IN/DECODER connector, depending on the connector being used.

●When using another recorder as the recording deck, refer to its instruction manual.

●When using the AV2 (L-2) IN/DECODER connector, set “L-2 SELECT” to “A/V” ( pg. 45).

C Set the edit mode.

See “PICTURE CONTROL” on page 55.

D Start the source player.

Engage the Play mode of the source player.

E Start the recording deck.

Engage the Record mode of the recording deck.

NOTES:

●All necessary cables can be obtained from your dealer.

●For Y/C signal input/output, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.

●When you select “EDIT” to dub tapes in step 3, be sure to select “AUTO” (or “NORM” when “B.E.S.T.” is set to “OFF”) after you finish dubbing the tapes.

●When you use this recorder as the source player for editing, be sure to set “O.S.D.” to “OFF” before starting ( pg. 55).

●If you are using another recorder with S-Video and Audio input/output connectors, you can connect those connectors to this recorder’s S-VIDEO and AUDIO input/output connectors. When using your recorder as the source player ...

... connect its rear panel S VIDEO OUT and AUDIO OUT connectors to the recording deck’s S-Video and Audio input connectors.

When using your recorder as the recording deck ...

... connect its front panel S-VIDEO and AUDIO input connectors to the source player’s S-Video and Audio output connectors. Then, set the recorder’s input mode to “S-1”.