three step quick start 11

FINISH AUTO SETUP

Press and move on to Step 2 to check the results.

oops! If there is a power cut or you accidentally press a button during Auto Setup, turn the VCR off and then on again. Re-perform Auto Setup.

Preset Download

before you start

Check that the VCR is turned off and no cassette is inserted

Load the batterys into the Remote Control

Refer to the Remote Control diagram on pages 6–7

START PRESET DOWNLOAD

Press the obutton. The display panel on the front of the VCR will show the word ‘Auto’. Press the PR or PR button to select

‘CH – –’ and press (or E).

what will happen? The VCR is automatically setting up the tuner channels by downloading from your TV, clock and the VIDEO Plus+ system assigned Guide Program numbers. During downloading, preset position on the display panel increases from “CH1”.

SAT

VCR

REVIEW

SAT

VCR

REVIEW

Preset Download is running:

don’t touch any buttons

Unless indicated otherwise, use the buttons on the Remote Control

rf and scart connection If the TV set is in its AV mode (see the TV manual), you will see the following information displayed on your TV screen:

Check that the connection is completed

Be sure to use the fully- wired 21-pin SCART cable

Turn on the TV whose channels have already been stored

– –:– –

T-V LINK

PLEASE WAIT

Your TV screen during Preset

[MENU]: EXIT

Download

 

SET THE VIDEO CHANNEL TO OFF

 

 

When Preset Download has finished, ‘COM-

 

 

 

 

 

SAT

 

 

PLETED’ appears on the TV screen. Press oto

 

VCR

turn off the VCR. Press and hold down Son

 

 

REVIEW

 

 

 

 

 

 

the VCR until you will see the display on the

 

 

right. Press PR --on the Remote Control until the figure reads ‘– –’.

 

 

AUDIO – –:– –

 

3

 

VPS/PDC

 

 

0000

 

i

 

5

?

30 SEC

 

ENTER

PR

PR3

PR

i

2 4

ENTER

LP00000-000

VCR/TV

PR

3

PR

FINISH PRESET DOWNLOAD

Press and move on to Step 2 to check the results.

oops! If there is a power cut or you accidentally press a button during Preset Download, turn the VCR off and then on again. Re-perform Preset Download.

NOTES

•In areas where no TV station transmits the PDC signal, the VCR cannot setup either the clock or Guide Program numbers.

•On this VCR, the characters available for station names (ID) are A–Z, 0–9, –,

*, + and (space). The names of some downloaded stations may differ from those on your TV.