Before Operation - VCR part

Tuning in a video channel on your TV

Notes

The output frequency of this video recorder (VCR) is set at UHF channel 22. If channel 22 is already used by another TV station, or if the picture is distorted, you can change the transmitter channel of your VCR. Stages 5 ~ 8 will show you how to change the output frequency of your VCR.

Your TV receives signals from the video recorder (VCR) like another TV station. You have to select a channel number on your TV and tune it in so that you may watch video tapes. If you have used a SCART cable then your TV should already have a dedicated video channel built into it, usually called AV.

1 Make sure that you have correctly installed your VCR as described earlier in this book.

Press POWER to turn on your VCR. Turn on your TV.

2Insert a pre-recorded video tape into your VCR and press PALY G on the remote control.

Select a TV channel number on which you wish to watch video’s.

Don’t worry if you don’t have a video-tape to play at this stage! If you switch your VCR on and continue stages 3 ~ 4, instead of seeing video playback tune your TV until you see a bright blue screen.

3Tune this channel until the video picture is sharp and the sound is clear.

If you have used a SCART cable you will not have to tune your TV, simply select the AV channel. The AV channel is already pre-tuned for optimum video playback on your TV.

4Store this channel on your TV.

You will need to look at the TV instruction book if you do not know how to do this.

5Only carry out stages 5 ~ 8 if you cannot obtain clear video playback as described in stages 1 ~ 4. Select a TV channel number on which you wish to watch video’s.

Make sure that your VCR is in standby pressing POWER on the remote control (only the clock will be displayed).

6Press PR - or PR + on the front of your VCR for more than 4 seconds.

RF22 will appear in the display window.

The following picture will be displayed on the TV screen.

RF CHANNEL 22

P

i

RSET

7Press PR - or PR + to select another video channel. You may select any channel number between 22 and 68.

You can also set it to “OFF” if there is any interference when your TV is connected to the VCR with a SCART lead.

8Select a TV channel number on which you wish to watch video’s.

Press I on the front of your unit when you have finished.

Tune this channel so that a bright blue screen appears.

Store this channel on your TV.

Note

Make sure that you have correctly installed your VCR and successfully tuned in a dedicated video channel on your TV. If you do not tune in a dedicated video channel on your TV you will be unable to view and record video tapes!

Initial preset

For the following steps we do assume that you have just connected your video recorder for the very first time. In this case the video recorder is on after mains connection. You should not touch any buttons yet. On the connected TV you will now see initial menu picture screen.

Note - If this menu does not appear, your video recorder was programmed already.

1connected to your VCR, switched on and Sky News has been selected.If you have a satellite receiver make sure that it is

 

D

 

ACMS

Pr-12

OK i

ACMS

2 Press OK to start the automatic storing of the channels of the TV stations in your area.

01 C02 00 BBC1

 

 

 

 

 

 

 

 

Pr-12 S

 

 

 

E

ACMS

i

PREPARATION

13