The remote control is capable of controlling four JVC video units independently. Each of units can respond to one of four codes (A, B, C or D). The remote control is preset to send A code signals because your unit is initially set to respond to A code signals. You can easily modify your unit to respond to B, C or D code signals.
Before performing the following steps:
Slide the TV/VCR/DVD switch to the right.
POWER
VCR DVD
TV
1 - 2
TV
| DVDMENU | MEMORY | SEARCH |
| |
|
|
|
| EJECT | |
|
| SUBTITLE | ANGLE |
| |
| DISPLAY |
|
| RETURN | |
| ZOOM | TITLE | REPEAT | ||
| 1 | 2 | 3 | SHOWVIEW | |
1 | VIDEOPlus+ | ||||
|
|
| |||
| 4 | 5 | 6 |
| |
| 7 | 8 | 9 |
| |
| 0 | TV |
| TV | |
|
| TV/VCR |
| ||
|
|
|
| 5 | |
|
| TV/VCR PR + |
| ||
|
| OK | 2 | ||
|
|
|
| 0000 | |
|
|
|
| CANCEL | |
|
|
|
| M | |
|
| TV/VCR PR | NDO | ||
|
| RA | |||
| AUX | AUDIO | PROG. |
| |
|
| MONITOR |
| ||
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 4 |
| |
| 3 |
| ||||
|
|
|
|
|
|
|
On the remote control
Keep pressing VCR down during steps 1 – 2.
1Press the number key “1” for A, “2” for B, “3” for C or “4” for D.Change the remote control code.
2 Set the remote control code.
Press OK to set the code.
On the unit
3 Press 
I .
4Press PLAY 
on the unit for over 5 seconds while the unit is turned off. The code currently set appears on the front display panel.
If the code displayed on the front display panel is
different from the code set on the remote control, go to step 5.Display the code.
Change the unit’s code.
5 Press Á on the remote control. The code currently set on the remote control will be applied to the unit.
Note
Once you have set the remote control to operate the TV, you do not have to repeat this step until you replace your remote control’s batteries or until you pull out the power cord.
8