JVC HR-XV45SEK, 3834RV0038A Before Operation-VCR part, Using your VCR for the very first time

Before Operation-VCR part

Tuning in a video channel on your

TV

Notes:

The output frequency of this DVD+VCR is set at UHF channel 36. If channel 36 is already used by another TV station, or if the picture is distorted, you can change the transmitter channel of your DVD+VCR. Stages 5 ~ 8 will show you how to change the output frequency of your DVD+VCR.

Your TV receives signals from the DVD+VCR like another TV station. You have to select a channel number on your TV and tune it in so that you may watch video tapes. If you have used a SCART then your TV should already have a dedicated video channel built into it, usually called AV.

1.Make sure that you have correctly installed your DVD+VCR as described earlier in this book. Press 1/+ to turn on your DVD+VCR.

Turn on your TV.

2.Insert a pre-recorded video tape into your DVD+VCR and press N on the remote control. Select a TV channel which you wish to watch video.

Don’t worry if you don’t have a video-tape to play at this stage! If you switch your DVD+VCR on and continue stages 3 ~ 4, instead of seeing video playback tune your TV until you see a bright blue screen.

3.Tune this channel until the video picture is sharp and the sound is clear.

If you have used a SCART or AUDIO and VIDEO cables you will not have to tune your TV, simply select the AV channel. The AV channel is already pre-tuned for optimum video playback on your TV.

4.Store this channel on your TV.

You will need to look at the TV instruction book if you do not know how to do this.

5.Only carry out stages 5 ~ 8 if you cannot obtain clear video playback as described in stages 1 ~ 4.

Select a TV channel which you wish to watch video.

Make sure that your DVD+VCR is in standby pressing 1/+ on the remote control (only the clock will be displayed).

6.Press PROG. (-/+)on the front of your DVD+VCR for more than 4 seconds.

RF36 will appear in the display window.

The following picture will be displayed on the TV screen.

RF CHANNEL 36

7.Use PROG. (-/+)to select another video channel. You may select any channel number between 22 and 68.

8.Select a TV channel which you wish to watch video.

Press 1/+ on the front of your DVD+VCR when you have finished.

Tune this channel so that a bright blue screen appears.

Store this channel on your TV.

Notes:

Make sure that you have correctly installed your DVD+VCR and successfully tuned in a dedicated video channel on your TV. If you do not tune in a dedicated video channel on your TV you will be unable to view and record video tapes!

Using your VCR for the very first time

Following picture will display on the TV screen when you have just connected your video recorder for the very first time.

To make tuning TV stations, please follow stages 3 to 4 as shown "ACMS" (see p.14).

	ACMS
Pr-12	OK i
ACMS

12