English

To connect the AM loop antenna

1 Hold

3 Release

 

2Insert

•If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl.

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also, keep the antennas away from metallic parts of the System, connecting cords, and the AC power cord. This could cause poor condition.

To connect the speaker cords

1 Hold

3 Release

2 Insert

Speaker

Speaker

cords

cords

(black/blue)

(black/blue)

 

Speaker cords

 

(black/red)

From right speaker

From left speaker

•When connecting the speaker cords, match the polarity of the speaker terminals: (+) to (+) and (–) to (–).

•Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

•The speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, it may cause color distortions. So, pay attention to the following when installing the speakers.

–When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers.

Then wait at least 30 minutes before turning on the TV’s main power switch again.

•Some TVs may still be affected even though you have followed the above. If this happens, move the speakers away from the TV.

•DO NOT connect more than one speaker to each terminal.

•DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

To connect digital audio

OPTICAL

DIGITAL

OUTPUT

Before connecting optical digital cord, remove the protective cap from the OPTICAL DIGITAL OUTPUT terminal.

To connect the AV COMPU LINK cords

The AV COMPU LINK control system allows you to use JVC’s TV with simple operations; by starting playing back a disc, the TV automatically turns on and changes the input mode to the appropriate position so that you can view the playback picture.

To use AV COMPU LINK, you need to connect the unit and the TV by using a cord with monaural mini-plugs (not supplied) in addition to the connection with a video cord (see page 4).

To connect other equipment

By using an stereo mini plug cord (not supplied), you can connect equipment with analog audio output jacks such as an MD player, a TV, etc.

Stereo mini plug cord (not supplied)

AUX

Portable audio device,

Game, etc.

(front panel)

If the audio output on the other equipment is not stereo mini plug type, use a plug adapter to convert the stereo mini

plug to the corresponding plug of the audio output.

IMPORTANT

Always set volume to MIN when connecting or disconnecting the other equipment.

DO NOT plug in any equipment until all connections are complete.

6