Select 6 for IP Settings. The IP Settings Menu appears:
IP Settings
1. IP Address 192.168.1.42
2. Subnet 255.255.255.0
3. Gateway 0.0.0.0
4. Web Port 80
5. Telnet Port 23
6. Message Port 9100
7. MTU 1024
8. Write Community Name private
9. Read Community Name public
A. SNMP Manager 1 192.168.1.97
B. SNMP Manager 2 0.0.0.0
C. SNMP Manager 3 0.0.0.0
D. SNMP Manager 4 0.0.0.0
X. Exit
K-16>
Enter the IP address, Subnet Mask and Gateway in Dotted Decimal Format.
Setting IP address via Serial Port The serial port uses the same menu sequences as the Telnet method described above. Connect a
terminal directly to the C-AB-16-R serial port. Send an Enter keystroke to start the session. The serial
port default settings are 9600bps, 8 data bits, no parity, one stop bit. These setting can also be changed
via the menus.
Setting IP Address with setip.exe Utility setip.exe is available from Dataprobe’s website at http://www.dataprobe.com/files/control/setip.exe.
Download this windows program and run it on any computer on the same physical network segment as
the control card. Enter the MAC address and desired IP address and press SetIP.
Setting other Parameters Via the Serial Port (or telnet on the C-AB-16-R) , all other configuration parameters can be set for the C-
AB-16-R . These setting are made from the Setup Menu, as described in the section 3.1.3 above.
Location Name: Enter a 1-20 character name to identify the system. This name appears at the top of
each telnet screen and web page.
Card Setup: This allows setting of parameters for individual A/B cards in the system. Each card can be
named, up to 20 characters, and can be enabled or disabled. Disabling a card hides its status from web
and telnet screens. This should be used where no card is installed, to make reading the screens easier.
NOTE: Only the 1st three AB card slot positions of the 16 displayed are used in the K3. Displayed
Slots 4 thru 16 are non functional.
Password: A password from 1 to 15 characters is needed for access to the system. Re-enter the old
password then enter the new password twice as prompted.