e_ka250.book Page 10 Tuesday, September 5, 2006 4:10 PM
PREPARATIONS
Installation
Mounting on a Tripod
Use the screw holes on the bottom to mount on a tripod. There are multiple screw holes. Use
Screw holes
2.Release the LOCK RELEASE LEVER.
Push the safety lever until the front attachment clip clicks, and then pull the lock lever.
Lock lever
Safety lever
3.Position the camera.
Position the camera so the rear base mount is aligned with the pin on this device.
Mounting the Camera
Prepare the camera as follows before mounting.
•Attach the lens.
•Attach the microphone.
•Remove the viewfinder.
For details, refer to
1.Open the side cover.
Rear base mount | Front base mount |
4.Lock the camera.
Hold the camera on the top and slide forward. The front base mount of the camera and the front attachment grip of this device locks and clicks.
CAUTION
•The front base mount may lock even when the pin on this device and the rear base mount attachment hole on the camera is not attached. After attaching, confirm that the camera has been firmly attached. The camera may fall and cause injury or accident if it is not attached properly.
•When transporting with the camera attached to this device, hold the bottom of this device. If transported with the camera handle, the attachment may come off and this device may fall and cause injury or accident.
10
