JVC KA-HD250 manual Controls, Indicators and Connec- tors Cont’d Rear Section, Bottom Section

e_ka250.book Page 8 Tuesday, September 5, 2006 4:10 PM

INTRODUCTION

Controls, Indicators and Connec- tors (Cont’d)

Rear Section

g

INTERCOM DC INPUT

PUSH

INTERCOM MIC	INTERCOM LEVEL	CALL
ON
OFF	MIN MAX

h i j k l

g[TALLY] TALLY Lamp

Lights up red when GY-HD250 is in RECORDING mode. Blinks red when preparing RECORDING mode and lights up green when in stand-by.

h[INTERCOM] Intercom Input Terminal (XLR 5 Pin) Input terminal for intercom headset. (Dynamic only) Recommended headset: DT109 (Beyerdynamic)

1	5		Signal
		1	MIC (H)
		2	MIC (C)
2	4	3	EAR (C)

34 EAR (H) – LEFT

(Surface profile) 5 EAR (H) – RIGHT

i[INTERCOM MIC] Intercom Mic [ON/OFF] Switch [ON/OFF] switch for intercom headset microphone. Set to [ON] to use the headset microphone.

j[INTERCOM LEVEL] Intercom Receiver Volume

Use for adjusting the intercom headset receiver volume level.

k[CALL] CALL button/Power indicator

Lights green when the studio adapter is turned on.

Press to send call signal to the remote control unit opera- tor if intercom headset is not in-use.

Button indicator changes from green to red when the but- ton is pressed.

When this button is pressed and held down, call signal is sent to the remote control unit and the [TALLY] indicator blinks. Once the [CALL] button is released, call signal is no longer sent and the [TALLY] indicator of the remote control unit turns off.

l[DC INPUT] DC Power Input Terminal (XLR 4 Pin) Connect DC power to this terminal if Remote Control Unit RM-P210 is not connected. For DC power supply, use the IDX IA-60a or VL-2PLUS.

CAUTION

When cable is connected to the DC INPUT terminal while supplying power from the RM-P210, power will flicker. Turn off connected devices when connecting a cable to the DC INPUT terminal.

Bottom Section

m

mScrew Holes for Mounting Tripod

8