JVC KA-MR100G Warning Messages, Error Messages, Battery and Signal Error Messages, Card Error Messages, Others

Others

Warning Messages

When warning messages appear on the LCD panel, take the following actions.

WRITE	Warning Messages
PROTECT!

Message	Description
CLOCK	Appears when the clock is not set.
SETUP	Action: Set the clock when the [CLOCK1]
MENU	setting screen appears.
WRITE	Appears when the write-protect switch of
PROTECT!	the SxS memory card is set to the “WP”
	end.
	Action: Set the write-protect switch to AOffB
	before recording or deleting a clip.
CARD FULL!	Appears when there is no more space left
	on the SxS memory card.
	Action: Take any of the following actions.
	● Use an SxS memory card with sufficient
	space.
	● Delete unwanted clips or format the card
	to create space.
OPERATION	Appears when buttons other than the
LOCK !	[MENU] button is pressed with the
	[OPERATION] menu set to ALOCKB.
	Action: Change the [OPERATION] menu
	setting to AUNLOCKB.

Error Messages

Battery and Signal Error Messages

An error message appears at the first line of the LCD panel display when the battery is weak or when there is an input signal error. When an error message appears, take the following actions.

Message	Description
BAT.	Appears when the remaining battery level
ALARM !	is insufficient.
	Action: Charge the battery.
SHUT	Appears immediately before the battery
DOWN !	runs out completely. The memory recorder
	will shut down a few seconds after the
	message is displayed.
	Action: Charge the battery.
NO SIGNAL !	Appears when there is no signal input.
(*1)	Action: Check the connection of the
	IEEE1394 cable and the camcorder
	settings.
Other	Appears when the format of input signals is
SIGNAL (*1)	different from that of the memory recorder.
	Action: Make sure that the memory
	recorder settings are consistent with those
	of the camcorder. (A Page 9)

(*1) Appears during the recording or stop mode.

Card Error Messages

When an SxS memory card incompatible with the memory recorder is detected, an AERROR CARD!B message and a message indicating the cause of the card error will appear alternately at the first line of the LCD panel display. (For approximately two seconds) When an error message appears, take the following actions.

Message	Description
NO	Appears when a media not supported by
SUPPORT!	the memory recorder is inserted.
	Action: Replace it with a recommended
	SxS memory card.
FORMAT!	Appears when the card has already been
	formatted by another device.
	Action: Execute AFORMATB using this
	memory recorder.
	“Menu screen’s [MEDIA]->[FORMAT]
	settings” (A Page 13)
CARD	Appears when errors are found in the clip.
CHANGE	Action: Execute ARESTOREB or
	AFORMATB using this memory recorder. If
	doing so does not eliminate the error, it
	may be due to malfunction of the SxS
	memory card. Replace the SxS memory
	card.
RESTORE !	Appears when the clip may be damaged.
	Action: Execute ARESTOREB using this
	memory recorder.

Card error message appears when the following operations are performed.

●When an SxS memory card is inserted

●When power is turned on with an SxS memory card inserted

When in the stop, standby or still mode

Status screen (stop or standby)

<LCD Panel>

Clip selection screen (still)

<LCD Panel>

When in the menu screen display

<LCD Panel>

14