Manual preset

You can preset up to 6 stations in each band (FM1, FM2, FM3, and AM) manually.

Ex.: Storing FM station of 92.5 MHz into the preset number 1 of the FM1 band.

1 Select the band (FM1 – 3, AM) you want to store stations into (in this example, FM1).

Each time you press the button, the band changes as

follows:

FM1 FM2 FM3 AM

2 Tune in to a station (in this example, of 92.5 MHz).

To tune in to stations of higher frequencies

To tune in to stations of lower frequencies

4 Repeat the above procedure to store other stations into other preset numbers.

Notes:

A previously preset station is erased when a new station is stored in the same preset number.

Preset stations are erased when the power supply to the memory circuit is interrupted (for example, during battery replacement). If this occurs, preset the stations again.

Tuning in to a preset station

You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 9 and 10.

1 Select the band (FM1 – 3, AM).

Each time you press the button, the band changes as

follows:

FM1 FM2 FM3 AM

3 Press and hold the number button

2 Select the number (1 – 6) for the

preset station you want.

(in this example, 1) for more than

 

2 seconds.

 

Preset number flashes for a while.

10

Page 10
Image 10
JVC KD-G502 manual Tuning in to a preset station, Manual preset, Preset number flashes for a while