To select the subwoofer cutoff frequency
– CUTOFF F
When a subwoofer is connected to this unit, select an appropriate cutoff frequency level for your subwoofer.
When shipped from the factory, the subwoofer cutoff frequency is set to “FREQ MID.”
•FREQ LOW: Frequencies higher than 50 Hz are cut off to the subwoofer.
•FREQ MID: Frequencies higher than 80 Hz are cut off to the subwoofer.
•FREQ HIGH: Frequencies higher than 120 Hz are cut off to the subwoofer.
To adjust the line input level – LINE ADJ
Adjust the line input level properly when an external component is connected to the LINE IN plugs.
When shipped from the factory, the line input level is set at level 00.
If the input level of the connected component is not high enough, increase the input level properly. Without adjusting the line input level, you may be surprised at a loud sound when you change the source from the external component to another source.
To adjust the auxiliary input level
– AUX ADJ
Adjust the auxiliary input level properly when an external component is connected to the Auxiliary input jack.
When shipped from the factory, the auxiliary input level is set at level 00.
If the input level of the connected component is not high enough, increase the input level properly. Without adjusting the line input level, you may be surprised at a loud sound when you change the source from the external component to another source.
To select the target component to operate through this receiver – KEY SELECT
You can operate either JVC’s DVD player or VCR through this receiver, by using the number buttons on the control panel.
When shipped from the factory, these number buttons are set to be used for the DVD operations.
To use these number buttons on the control panel for DVD or VCR operations, see page 37.
To change the FM tuner selectivity |
| |
ENGLISH | ||
may be heard. This unit has been preset to | ||
– IF FILTER |
| |
In some areas, adjacent stations may interfere |
| |
with each other. If this interference occurs, noise |
| |
automatically reduce this interference noise |
| |
| ||
(“AUTO”) when shipped from the factory. |
|
•AUTO: When this type of interference occurs, this unit automatically increases the tuner selectivity so that interference noise will be reduced. (But the stereo effect will also be lost.)
•WIDE: Subject to the interference from adjacent stations, but sound quality will not be degraded and the stereo effect will not be lost.
To turn the demo mode on or off – DEMO MODE
You can turn the demo mode on or off. When shipped from the factory, “DEMO ON” is selected.
•DEMO ON: Turns the demo mode on. The demonstration will start automatically if no sound comes in for 3 minutes.
•DEMO OFF: Turns the demo mode off.
Note:
If the unit has been reset (and the power is on), demonstration will start if no sound comes in for about 10 seconds.
To turn the tag display on or off – TAG DISP
An MP3 file can contain file information called “ID3 Tag” where its album name, performer, track title, etc. are recorded.
There are two versions–ID3v1 (ID3 Tag version
1)and ID3v2 (ID3 Tag version 2). This unit is compatible only with ID3v1.
When shipped from the factory, “TAG ON” is selected.
• TAG ON: | Turns on the ID3 tag display |
| while playing MP3 files. |
| * If an MP3 file does not have |
| ID3 tags, directory name and |
| file name appear. |
| Note: |
| If you change the setting from “TAG |
| OFF” to “TAG ON” while playing |
| an MP3 file, the tag display will be |
| activated when the next file stars |
| playing. |
• TAG OFF: | Turns off the ID3 tag display |
| while playing MP3 files. (Only the |
| directory name and file name can |
be shown.) | 33 |
|
