JVC LM-H191, LM-H171 manual Installation, To detach the stand

Models: LM-H191 LM-H171

1 18
Download 18 pages 39.84 Kb
Page 5
Image 5
Installation

Installation

CAUTION

Do not rest your arm on the monitor or lean against the monitor.

Do not touch the LCD panel when installing the monitor.

Make sure to install the monitor securely to prevent the monitor from falling over, which causes damage to the monitor or injury.

You can tilt the monitor as follows:

• When the monitor is not tilted (0°), the guidelines align as illustrated.

4

To detach the stand

CAUTION

Lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.

Attachment screws

Screw holes for stand attachment

About 20°

0° About 8°

The illustration of the monitor is of LM-H191.

Guidelines

CAUTION

Be careful not to pinch your fingers in the gap between the monitor and the stand.

When the stand plate is attached to the lower position of the stand body (“To adjust the stand height” on page 5), you cannot tilt the monitor downward.

You can lift the stand up and place the monitor as illustrated below.

The illustration of the monitor is of LM-H191.

About 144°

Remove the screw.

Lift the stand up and align the guidelines.

Guidelines for 144°

Attach the removed screw.

CAUTION

When lifting up the stand, lay the monitor on a cloth with the LCD panel facing down to prevent the LCD panel from being damaged.

Be careful not to pinch your fingers in the moving parts.

When lifting up the stand, make sure to align the guidelines for 144° and fasten the screw; otherwise the monitor may fall over.

Place the monitor on a mat to avoid scratching the table surface.

Do not lift up the stand when the stand plate is attached to the lower position of the stand body (“To adjust the stand height” on page 5).

When installing the stand to the monitor, insert the guides of the stand plate into the guide holes on the monitor to place the stand on the correct position. Then fix the stand firmly with the attachment screws.

Guide holes

Guides

Monitor

Screw holes for stand attachment

 

 

(on the monitor)

To detach the stand Stand plate

Screw holes for stand attachment (on the stand)

The illustration of the monitor is of LM-H191.

Page 5
Image 5
JVC LM-H191, LM-H171 manual Installation, To detach the stand