EN 45
The VFP (Video Fine Processor) function enables you to adjust the picture character according to the type of programming, picture tone or personal preference.
NOTE:
Before you start operation;
The VFP setting screen disappears if no operations are done for more than about 10 seconds. If the setting screen disappears before you finish, start from step 1 again.
1Access the VFP setting menu.Press DVD PICTURE during |
|
|
|
|
|
|
|
| |
playback. |
| NORMAL |
|
|
● The current setting appears on |
| GAMMA | 0 |
|
| BRIGHTNESS | 0 |
| |
the TV screen. |
| CONTRAST | 0 |
|
|
| SATURATION | 0 |
|
|
| TINT | 0 |
|
|
| SHARPNESS | +3 |
|
|
|
|
|
|
Press rt repeatedly to select a parameter you want to adjust, then press ENTER.
●Adjust gradually and confirm picture appearance results are as preferred.
GAMMA: Controls brightness of neutral tints while
BRIGHTNESS: Controls screen brightness.
CONTRAST: Controls screen contrast.
SATURATION: Controls screen color depth.
TINT: Controls screen tint.
SHARPNESS: Controls screen sharpness.
●VFP menu disappears and the following
Press w e repeatedly.
●Each time you press w e, the VFP mode changes as follows:
NORMAL]CINEMA]USER 1]USER 2](Back to the beginning)
NORMAL: Select this normally.
CINEMA: | Suitable for movie. |
USER 1/USER 2: You can adjust parameters that affect picture appearance and store settings. Go to step 3.
NOTE:
You cannot adjust the parameters of “NORMAL” and “CINEMA”.
To adjust picture appearance manuallyGAMMA 0
GAMMA 0
●The selection menu disappears automatically if you do not change the selection for 10 seconds.
5Adjust the parameter.Press rt repeatedly to change the setting, then press
ENTER.
●The current VFP settings appear again.
6Adjust the other parameters.Repeat steps 4 and 5 to adjust other parameters.
To return to the normal screenPress DVD PICTURE.To activate your settingPress w e repeatedly to select “USER 1” or “USER 2”.
USER 1
GAMMA 0
BRIGHTNESS 0
CONTRAST 0
SATURATION 0
TINT0
SHARPNESS +3
Press DVD PICTURE, then press w e repeatedly to select “USER 1” or “USER 2” that you have changed the parameters.