No-Signal Detection (TV mode)

If no valid signal detected, it takes 5 minutes to switch to the Stand-By mode unless any signal detected or any Remote Control command is accessed.

After a Remote Control command (if No-Signal Timer is active) the timer stops and if no signal detected again the timer is initialized to 5 minutes and starts 3 seconds later again to count down.

It is not valid in EXT modes.

No-Signal and Out Of Range Detection (PC mode)

In PC Mode, as no menu is displayed, in case that there is no PC input to the TV, it is displayed an OSD message:

No input signal detected

then the power lamp turns to amber and PC will be in PC standby mode. Press “AV” but-

ton, digit buttons or “” / “” buttons to exit standby mode.

In PC Mode, if the resolution and the vertical frequency is not supported by the concept, it is displayed an OSD message:

Signal out of range

Volume Bar

It is displayed in the lower middle of the screen. When a volume command is received (press- ing “ +” or “ -” by Remote Control or Control panel on the right side of the TV) and no menu is active, it stays on the screen for 3 seconds, after the last volume command or until another command is received in between.

EXT Modes

By pressing the “AV” button you can switch your TV to EXT modes (except being in Tele- text). Pressing this button consecutively will switch the TV in one of the optional EXT modes: EXT-1,EXT-2,EXT-2 S, EXT-3,EXT-3 S and PC.

In order to quit the EXT mode press any digit

buttons or “” or “”.

Zoom Modes

Zoom mode can be changed by pressing the Red button. You can change the screen size according to the picture aspect ratio. Select the optimum one from the following ZOOM modes.

AUTO:

When a WSS (Wide Screen Signalling) sig- nal, which shows the aspect ratio of the pic- ture, is included in the broadcast signal or the signal from an external device, the TV automatically changes the ZOOM mode to 16:9 ZOOM mode, PANORAMIC or FULL mode according to the WSS signal.

•When the AUTO mode does not function cor- rectly due to poor WSS signal quality or when you want to change the ZOOM mode, change to another ZOOM mode manually.

Using the different screen formats

Press the Red button to select the different modes:AUTO,FULL,REGULAR,PANORAMIC, 14:9ZOOM,16:9ZOOM,16:9ZOOMSUBTITLE modes.

You can change the position of the picture in Zoom modes, except Full and Regular modes, by pressing the “” or “” button.

Note: You can only choose REGULAR and FULL in PC mode.

FULL:

This uniformly stretches the left and right sides of a normal picture (4:3 aspect ratio) to fill the wide TV screen.

•For 16:9 aspect ratio pictures that have been squeezed into a normal picture (4:3 aspect ratio), use the FULL mode to restore the pic- ture to its original shape.

ENGLISH - 21 -