INTRODUCTION
5Supplied Accessories
remote control |
| batteries | Phillips pan screw for |
| (AA x 2) | attaching the stand x 3 | |
|
|
|
|
•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.
•Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.
5Attaching the Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
Spread a thick and soft cloth over a | Insert the stand all the way to the |
1 table. | 2 main unit slowly until it clicks. |
Place the main unit face down onto it. | Make sure not to put the AC power |
Make sure not to damage the screen. | cord between the stand and the |
At least two people are required at | unit. |
this step. |
|
| f |
| r |
| o |
| ntsi |
| de |
Unscrew the Phillips pan screws indicated by“ 1 ”, then lift the lever on the bottom stand and remove the stand from the unit slowly. Be careful not to drop the stand when you remove it.
3 Drive Phillips pan screws in the 3 threaded holes at the bottom of the stand with a screwdriver tightly.
1screw holes
lever
•When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.
•Make sure to use a table which can support the weight of this unit and is larger than this unit.
•Make sure the table is in a stable location.
5Symbols Used in this Manual
The following is the description for the symbols used in this manual.
Description refers to:
DTV : Digital TV operation
TV : Analog TV operation
• If neither symbol appears under the function heading, operation is applicable to both.
4
EN