JVC P-VSDT6, LVT0853-009B manual Troubleshooting, Symptom, Possible Cause, Action

Troubleshooting

•If you are having a problem with your System, check this list for a possible solution before calling for service.

•If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as your dealer, for service.

Symptom

No sound is heard.

Poor radio reception

The CD skips.

The CD does not play.

Unable to operate the Remote Control.

Operations are disabled.

“CD NO DISC” appears.

“CANNOT PLAY” or “UNFINALIZ” appears.

The characters and symbols on the display appear upside down.

Possible Cause

•Connections are incorrect, or loose.

•Headphones are connected.

•The antenna is disconnected.

•The AM Loop Antenna is too close to the System.

•The FM Wire Antenna is not properly extended and positioned.

The CD is dirty or scratched.

The CD is upside down.

•The path between the Remote Control and the sensor on the Unit is blocked.

•The batteries have lost their charge.

The built-in microprocessor has malfunctioned due to external electrical interference.

There is no disc loaded.

•The CD-R or CD-RW that hasn’t yet been finalized (including blank discs) has been inserted.

•The disc has been inserted with its label side down.

The DISP.SET switch on the rear panel of the Center Unit has not been set correctly.

Action

•Check all connections and make corrections. (See pages 4 to 8.)

•Disconnect the headphones.

•Reconnect the antenna securely.

•Change the position and direction of the AM Loop Antenna.

•Extend FM Wire Antenna to the best reception position.

Clean or replace the CD.

Put the CD in with the label side up.

•Remove the obstruction.

•Replace the batteries.

Unplug the System then plug it back in.

Insert a disc.

•Insert a CD-R or CD-RW that has been finalized.

•Remove the disc and insert it with the label side front or up. (See page 20.)

Set the DISP.SET switch correctly. (See page 10.)

28